TM6148.[Insert Length] added for insertion parts setting on YC8.pdf
SM T Softwa re Eng inee ring Group IM Ope ration s Y AM AHA MO T OR CO ., L TD. 1. Model and V ers ion 2. Over v i ew 3. Setting method 4. Mount ac ti on 5. Error Mes sa ge 6. Res trictions Re v i sion No . V ersion Chap…
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
1. Model and Version
2. Overview
3. Setting method
4. Mount action
5. Error Message
6. Restrictions
Revision No. Version Chapter
No.
Revised Contents
00 V3.42STD R1.000 All Created
The information in this message may be contained confidential and legally protected under
applicable law.
I intended this message for the addressee only.
I
f
y
o
u
a
r
e
n
o
t
t
h
e
i
n
t
e
n
d
e
d
r
e
c
i
p
i
e
n
t
,
y
o
u
a
r
e
h
e
r
e
b
y
n
o
t
i
f
i
e
d
t
h
a
t
a
n
y
u
s
e
,
f
o
r
w
a
r
d
i
n
g
,
dissemination, or reproduction of this message is strictly prohibited and maybe unlawful.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
Target model and version are as follows.
Target Model and Version
Model Version Remarks
YC8 V3.42STD R1.000 or later
Y.Fact V1.42STD R1.000 or later
A setting parameter for mounting operation of the insertion parts has been added.
Additional parameter is as follows.
[Insert Length]
[Insert Length] is set as length included in [Body Size Z].
(See Fig. 2.1)
By setting [Insert Length], it becomes possible to mount insertion parts below the board
surface.
This parameter can be set separately to each of parts.
Set insertion length (mm) to [Parts] - [Mount] - [N:Insert Length].
(See Fig. 3.1)
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
Before this parameter was added, it was adjusted with [A: Mounting Height (mm)].
However, after this setting was added, [A: Mounting Height (mm)] means actual push amount.
By setting [Insert Length], it is possible to mout parts below the board surface.
(See Fig. 4.1)
When the insertion parts are mounted, the height of mounted parts above the board surface
(parts height) is calculated by subtracting [Insert Length] from [Body Size Z]. This value is used
as parts height before carry-in that is decided at line distribution by Optimization, or used at
interference check between mounted parts and picked parts.