TDS_InJet_388_CRRD_ENG.pdf

STENCIL, MISPRINT, SQUEEGEE cleaning PUMPRINT cleaning CONFORMAL COATING removing PCB cleaning www.dct.cleaning TECHNICAL DATA SHEET InJet ® 388 CRRD Combo www.dct.cleaning CHAMBER Combo

100%1 / 8
STENCIL, MISPRINT, SQUEEGEE cleaning
PUMPRINT cleaning
CONFORMAL COATING removing
PCB cleaning
www.dct.cleaning
TECHNICAL DATA SHEET
InJet
®
388 CRRD
Combo
www.dct.cleaning
CHAMBER
Combo
InJet
®
388 CRRD
TECHNICAL DATA SHEET
2
www.dct.cleaning
GENERAL INFORMATION
The InJet 388 series cleaning systems represent
unique vertical Spray-In-Air technology developed
and manufactured by DCT.
The vertically installed Spray-In-Air device minimizes the
shadowing eff ect commonly seen in horizontal cleaners,
and maximizes the effi ciency of the cleaning process as
the cleaning  uid is sprayed directly onto the cleaned
component.
InJet
®
388 CRRD “Combo” including 100% closed loop with
processes of cleaning, pre-rinsing,  nal rinsing, and drying
technologies.
All of the processes are fully automated, and take place
in one process chamber.
The InJet
®
388 CRRD “Combo” is developed primarily for
precision PCBA.
The cleaning system can also be used for high-quality
removal of solder pastes and SMT adhesives from
stencils, PumPrints, squeegees and misprints, or the
aforementioned cleaning applications, along with PCBA.
The machine can also be used for the removal of cured
conformal coatings.
Depending on your cleaning requirements,
the DCT project manager, in collaboration
with a local distributor, will advise you
on a suitable water-based cleaning fl uid
and the correct setup of the entire process.
InJet
®
388 CRRD
TECHNICAL DATA SHEET
3
www.dct.cleaning
D
R
PRE-RINSING
PRE-RINSING
FILTER
RINSING
FILTER
CLEANING
FILTER
R
Application
name
Recommended
application
Recommended
temperature
Total cleaning
process time
Capacity
per 8 hours
Stencil, misprint, squeegee
20 – 40°C 68 – 104 °F 18 min. 27
PumPrint
40 – 55°C 104 – 131 °F 18 min. 27
Conformal coating
40 – 55°C 104 – 131 °F 60 min. 192 * /16 **
PCB
35 – 55°C 95 – 131 °F 30 min. 384 *
4 INDIVIDUAL PROCESSES
CLEANING PARAMETRES
C
CLEANING
PRE–RINSING
RINSING
DRYING
R
D
R
highly recommended recommended applicable
* PCB eurocards / per 8 hours (calculated for dimension of 100 x 160 mm / 3.94 x 6.3 in)
* * Parts in soldering palette / per 8 hours (320 x 500 x 50 mm / 12,6 x 19,7 x 1,97 in)
* * * Stencils, pumpprints larger than 736 x 736 mm / 29 x 29 in
LEGEND: