00197835-04_JC_PM_WF3_SX12_EN.pdf
www.asm-smt.com Preventive Maintenance Workflow 3 SIPLACE SX1/SX2 Job Card Edition 11/2020 EN
www.asm-smt.com
Preventive Maintenance Workflow 3
SIPLACE SX1/SX2
Job Card
Edition 11/2020 EN
All names identified by ® are registered trademarks of ASM Assembly Systems GmbH & Co. KG. The remaining trademarks in this publication may be trademarks whose use by third parties
for their own purposes could violate the rights of the owner.
We have reviewed the contents of this publication to ensure consistency with the hardware and software described. Since variance cannot be precluded entirely, we cannot guarantee full
consistency. However, the information in this publication is reviewed regularly and any necessary corrections are included in subsequent editions.
Copyright © ASM Assembly Systems Technical data subject to change
ASM Assembly Systems GmbH & Co. KG
Rupert-Mayer-Straße 44
81379 Munich
Germany
Item no.: 00197835-04
www.asm-smt.com Printed by ASM Assembly Systems
www.asm-smt.com
Introduction
Safety Introduction
Equipment required for Maintenance Workflow 3 SIPLACE SX1/2
1 Test the tape cutter.
2 Check the head status, remove tables (COT), exchange nozzles and
shut down machine
3 Empty and clean the reject bin.
4 Check the fans on the GCU / MGCU and switch off the machine.
5 If required exchange the head to be maintained.
6 Clean the Z-Axis of the remaining C&P20x.
7 Check and clean the X- and Y-Axis magnets.
8 Clean the X-Axis loose bearing and contact surface.
9 Clean the Y-Axis loose bearing and contact surface.
10 Clean and preserve the conveyor, lifting tables and gantry cables.
11 Clean / replace the head exhaust air filter.
12 Clean / replace the compressed air filter - version 1.
13 Clean / replace the compressed air filter - version 2.
14 Grease the cutter and cutting blades.
15 Check / grease the docking unit.
16 Check the guide roller and buffer at the protection covers.
17 Grease the X-Feeder tables.
18 Prepare the feeder, return all tables, close the covers and switch on
machine.
19 If required calibrate the head exchanged.
20 Check the filter discs of all C&P20x.
21 Check the nozzle seating of all C&P heads.
22 Check the anti glare shields of C&P20 A.
23 Endurance run.
24 Check the cover fans and clean the protection cover.
25 Appendix: C&P20x head exchange
26 Appendix: CPP head exchange
27 Appendix: TH head exchange
28 Appendix: Prepare the grease gun
29 Appendix: Calibrate the maintained C&P head
30 Appendix: Calibrate the TwinHead
Table of Contents