TS910-user-guide.pdf

TECHCON SYSTEMS

TS910

Squeeze Tube Gun

User Guide

CONTENTS

Page number

1. Specifications…………….……………………………………….3

2. Setup instructions ………….……………………………………3

3. Trouble shooting ….……………………………………………4

4. O-ring replacement ….……………………………………………5

5. Spare parts …………………..……………………………………6

6. Warranty ……………………………………………….7

10. LIMITED WARRANTY

Manufacturer warrants this product to the original purchaser for a period of

ninety (90) days from date of purchase to be free from defects in material and

workmanship, but not against damages by misuse, negligence, accident, faulty

installations and instructions. Manufacturer will repair or replace (at factory’s

option), free of charge, any component of the equipment thus found to be

defective, on return of the component “PREPAID” to the factory during the

warranty period. In no event shall any liability or obligation of the

Manufacturer arising from this warranty exceed the purchase price of the

equipment. This warranty is only valid if the defective product is returned as a

complete assembly without physical damage. The Manufacturer’s liability, as

stated herein, cannot be altered or enlarged except by a written statement

signed by an officer of the company. In no event shall the Manufacturer be

liable for consequential or incidental damages. A return authorization is

required from OK International prior to shipping a defective unit to the factory.

Manufacturer reserves the right to make engineering product modifications

without notice.

Send warranty returns to:

OK International

12151 Monarch Street

Garden Grove, Ca 92841

TSI-0071 Rev_A

No. Part number Description

1 910-TN Nozzle

2 910-25 Nozzle retaining nut

3 TSD1400-014A O-ring

4 910-3 Lock Ring

5 910-26 Body

6 910-2 Cap

7 910-8 Seal

8 910-13 Seal Retaining Ring

9 TSD923-1 Hose Barb Fitting

10 TSD1099-11 Air Hose, 5’

11 TSD922-1 Hose Fitting

12 TSD356-6 Air Connector

1. SPECIFICATIONS

Size: 7.5” (19.5 cm) x 6.5” (16.5 cm)

Weight: 0.60lb (0.27Kg)

Maximum pressure: 50.0 psi (3.44 bar)

Air inlet port: 1/8 NPT

Air hose length: 5.0’ (1.5 m)

2. SET UP INSTRUCTIONS

1. Assemble appropriate air connector fitting to end of air hose

assembly

2. Remove gun cap by rotating counterclockwise

3. Place Nozzle onto squeeze tube containing material to be

dispensed, make certain that nozzle is correctly and firmly

threaded onto squeeze tube

4. Place squeeze tube into gun assembly by inserting nozzle through

dispense end opening

5. Pull nozzle through opening until firmly seated then thread nozzle

retainer nut over nozzle. It may be necessary to hold the squeeze

tube to prevent rotation.

6. Install the gun cap back securely onto the gun assembly

7. Cut nozzle tip to desired dispensing orifice

8. Connect air hose assembly to air source

9. Turn up air pressure (50 psi max) and squeeze the gun trigger until

desired flow is achieved. Recommended starting pressure is 20

psi.

10. When dispensing process is completed, remove the gun cap

11. Hold the squeeze tube while removing nozzle retaining nut