TP1158_Function of Updating Nozzle Spec.pdf
SMT Software Engineeri ng Group IMOperationsYAMAHAMOTORCO. ,LTD. MD OC-SOFT50043 1/3 Function of Up dati ng Nozzle S pecificatio n Contents Function of Upd ating Nozzle Specification ..........…
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50043
1/3
Function of Updating Nozzle Specification
Contents
Function of Updating Nozzle Specification.................................................................................... 1
1. Introduction................................................................................................................................ 2
2. Explanation of function .............................................................................................................. 2
2.1. Summary............................................................................................................................. 2
2.2. How to use .......................................................................................................................... 2
3. Limitations ................................................................................................................................. 3
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50043
2/3
1. Introduction
The target model and the version are as follows.
Table1 Target model and Target version
Item Object Remarks
Target
Model
YS Series Mounter, YG300, YG12, YG12F
Y.FacT
Target
Version
YS Series Mounter, YG300, YG12, YG12F: V1.10STD R1.000 or later
Y.FacT: V1.10STD R1.000 or later
2. Explanation of function
2.1. Summary
This function is to update following parameter to YAMAHA standard setting.
[Setting] – [Specification Information] – [Mount Nozzle Specification]
[Setting] – [Specification Information] – [Side View Camera Spec] – [Nozzle Basic
Setting]
This function enable to update them to YAMAHA standard setting automatically.
2.2. How to use
The selection check box is added to update nozzle specification to application installer of
machine and Y.FacT. By default setting, it is ON. Normally please install the application with
checked them.
If you change them from default setting value, please memorize them and re-set after
installed.
SMT Software Engineering Group
IMOperationsYAMAHAMOTORCO.,LTD.
MDOC-SOFT50043
3/3
[Machine]
[Y.FacT]
3. Limitations
This function update only the specification of YAMAHA standard nozzle (Type *1 - *9). The
specification of special nozzle is not updated.