00193463-01 - 第112页
3 What to do when .. . User Manual SIPLACE S-25 HM 3.5 When you, as an operator, carry out a walk-through inspection S oftware Version SR.503.xx 04/2002 US Edition 112 Æ Check the posi tion of the stoppe r on th e PCB tr…
User Manual SIPLACE S-25 HM 3 What to do when ...
Software Version SR.503.xx 04/2002 US Edition 3.5 When you, as an operator, carry out a walk-through inspection
111
3.5 When you, as an operator, carry out a walk-through
inspection
Æ Make sure that the tape is correctly placed in the springs of the 8 mm S feeder module.
Fig. 3.5 - 1 Placing the tape in the springs of the 8 mm S feeder module
Æ Check to ensure that the tape foil removal container for the 8 mm S feeder module is full.
If it is full, then pull out the foil and cut it off with scissors.
NOTE
Tearing the foil instead of cutting it can lead problems with the tape removal mechanism. 3
Æ Check to ensure that the withdrawal space on the feeder module is the right size for the com-
ponent.
Æ Check to see if tape guides are being used on the feeder modules that are intended for different
tape widths.
Æ Check to see if the additional plastic guides are being used on the feeder modules that are in-
tended for tapes of different widths.
3 What to do when ... User Manual SIPLACE S-25 HM
3.5 When you, as an operator, carry out a walk-through inspection Software Version SR.503.xx 04/2002 US Edition
112
Æ Check the position of the stopper on the PCB transport.
Always position the stopper so that it is not placed within any cut-outs or recesses in the PCB.
Æ Check the magnetic supports on the lifting table. They must be arranged so that they do not
collide with components on the bottom of the PCBs.
NOTE
Splice the tapes early enough so that the feeder modules do not become empty or you will
experience prolonged down times.
However, do not splice the tapes too early because if you wind the end of the old tape onto
the new reel after splicing, the reel holding the new tape may become overfilled and the tape
will slip off the reel and become tangled up. This will again result in pick-up errors and pro-
longed down times. 3
Æ Place insertable shafts into the tape container when using large tape reels.
Æ Insert the dividing plates as shown in Fig. 3.5 - 2 and remember that the smallest division of the
tape container is a 2x division. This will help avoid placement errors.
User Manual SIPLACE S-25 HM 3 What to do when ...
Software Version SR.503.xx 04/2002 US Edition 3.5 When you, as an operator, carry out a walk-through inspection
113
Fig. 3.5 - 2 Dividing plates in the tape container
(1) Tape container
(2) Dividing plate
(3) Guide rail for the dividing plates on the front of the container
(4) Guide rail for the dividing plates on the back of the container
(5) Supporting rod for the dividing plates
Steps
A Insert the dividing plate with the nose under the guide rail on the front of the container.
B Push the dividing plate in direction (B).
C Engage the dividing plate on the supporting rod (5).