00193463-01 - 第50页
1 Introduction, technical data User Manual SIPLACE S -25 HM 1.15 Overview of the modules - PCB conveyor Software Version SR.503.xx 04/2002 US Edition 50
User Manual SIPLACE S-25 HM 1 Introduction, technical data
Software Version SR.503.xx 04/2002 US Edition 1.15 Overview of the modules - PCB conveyor
49
1
Clearance on PCB underside 25mm (standard), 40mm (option)
PCB transport height 830mm ± 15mm (standard)
900mm ± 15mm (option)
930mm ± 15mm (option)
950mm ± 15mm (SMEMA optional)
Stationary conveyor side Right (standard), left (optional)
Type of interface Siemens (standard)
SMEMA (option)
Component-free handling edge 3mm
PCB changeover time 2.5 s
Type of transportation synchronous or asynchronous
Components on each conveyor synchronous: different, asynchronous: same
PCB width on each conveyor synchronous: different, asynchronous: same
Ink spot recognition synchronous: not possible, asynchronous: possible
Automatic width adjustment synchronous: not possible, asynchronous: possible
1 Introduction, technical data User Manual SIPLACE S-25 HM
1.15 Overview of the modules - PCB conveyor Software Version SR.503.xx 04/2002 US Edition
50
User Manual SIPLACE S-25 HM 2 Operational Safety
Software Version SR.503.xx 04/2002 US Edition 2.1 Safety instructions
51
2 Operational Safety
2.1 Safety instructions
2.1.1 Conventions for the use of hazard symbols
This User Manual contains notes that must be observed to guarantee your personal safety and to
avoid damage to equipment. These notes are highlighted by warning triangles and are indicated
as follows according to the level of risk: 2
2
DANGER or 2
as used in this User Manual means that death, severe injury or considerable damage to equip-
ment will occur if the danger instructions are not followed. 2
2
WARNING or 2
as used in this User Manual means that death, severe injury or considerable damage to equip-
ment may occur if the warning instructions are not followed. 2
2
CAUTION or 2
as used in this User Manual means that slight injury or damage to equipment may occur if the cau-
tion instructions are not followed. 2
2
PLEASE NOTE 2
as used in this User Manual provides information on the product or indicates a part of the User
Manual that requires particular attention. 2
2.1.2 Qualified personnel
Qualified or adequately trained personnel means that these people are familiar with the setting up,
operation and maintenance of automatic placement systems and add-on devices and are suitably
qualified, e.g. 2
– have been trained, instructed or authorized to switch on and off, isolate, earth and identify elec-
trical circuits and system components in accordance with normal safety standards.