00193463-01 - 第71页
User Manual SIPLACE S-25 HM 2 Operational Safety Software Vers ion SR.503.xx 04/2002 US Edition 2.1 Safety instruc tions 71 Fig. 2.1 - 9 Securing the changeable component feeder table
2 Operational Safety User Manual SIPLACE S-25 HM
2.1 Safety instructions Software Version SR.503.xx 04/2002 US Edition
70
Æ Then carefully open the cross-beam clamp.
Æ Lower the cross-beam until the adjusting screw comes into contact with the latching disk.
Æ Tighten the cross-beam clamp.
Æ Then check the distance between the cross-beam and floor.
Æ Refit the internal paneling.
Æ Raise the table bed and remove the spacer block.
2.1.10 Safety instructions for the changeable component feeder table
If you use a changeable component feeder table rather than a mobile changeover table, then fol-
low these safety instructions to prevent injury or damage to machines. 2
WARNING 2
If you have installed a changeable component feeder table, do not forget to secure it with the two
M10 hexagon socket-head bolts (see item 1 and 2 in fig. 2.1 - 9). If you do not do this, the com-
ponent feeder table could tip over and the placement head could collide with the feeder as it ap-
proaches the feeder area. 2
User Manual SIPLACE S-25 HM 2 Operational Safety
Software Version SR.503.xx 04/2002 US Edition 2.1 Safety instructions
71
Fig. 2.1 - 9 Securing the changeable component feeder table
2 Operational Safety User Manual SIPLACE S-25 HM
2.1 Safety instructions Software Version SR.503.xx 04/2002 US Edition
72
2.1.11 Safety instructions for opening the protective covers
To prevent any risk of injury when the protective covers on automatic placement machines are
opened, the owner must instruct his operators to use the protective covers exactly as specified in
the following description. 2
RISK OF TRAPPING FINGERS IF THE PROTECTIVE
COVERS ARE OPENED OR CLOSED INCORRECTLY
When you open the protective covers, if you place one hand in one of the
recessed grips (1) and place the other hand on the protective cover in order to
guide it (item (5) in Fig. 2.1 - 10), you risk trapping your fingers in the narrow gap (4) between the
monitor traverse (3) and the protective cover (2). 2
Fig. 2.1 - 10 Protective covers on the SIPLACE automatic placement machine