HS50_advance_level 2 - 第272页
07/2002 Editio n Student G uide HS -50 Advanc ed II 9 Z-Axis 12 6HWWL QJV ➠ Use the bel t tens ion meas uring de vice to check the tensi on of th e toothed b elt (s ee setti ng instru ctions). ➠ T ighten the two…
Student Guide HS-50 Advanced II 07/2002 Edition
9 Z-Axis
11
.
(1) 4 x M3x5 hexagon socket-head screw with locking varnish
(2) Z-axis drive
(3) 2 x M2.5x12 hexagon socket-head screw
(4) Motor clamp fitting 2 / DLM1
(5) Motor clamp fitting / DLM1
(6) 2x M3x14 hexagon socket-head screw
➠ Carefully remove the Z-axis drive together with the cables.
)LWWLQJWKH=D[LVGULYH
➠ Insert the Z-axis drive.
➠ Make sure that the teeth of the toothed belts engage in the teeth of the motor pinion.
➠ Use the four M3x5 hexagon socket-head screws to fix the Z-axis drive.
➠ Tension the Z toothed belt by pushing the Z drive unit upwards.
07/2002 Edition Student Guide HS-50 Advanced II
9 Z-Axis
12
6HWWLQJV
➠ Use the belt tension measuring device to check the tension of the toothed belt (see setting
instructions).
➠ Tighten the two M3x14 hexagon socket-head screws (item 6 in Fig. 9.2 - 4) for fixing the motor
clamp (item 5 in Fig. 9.2 - 4
).
➠ Tighten the two M2.5x12 hexagon socket-head screws (item 3 in Fig. 9.2 - 4) for fixing the
motor clamp 2 (item 4 in Fig. 9.2 - 4
).
PLEASE NOTE:
Now tighten the hexagon socket head screws on the Z-drive unit and the motor clamp.
)UHTXHQF\+]
EHIRUHFRQWLQXRXVRSHUDWLRQ
)UHTXHQF\+]
DIWHUFRQWLQXRXVRSHUDWLRQ
Toothed belt T2 / DLM1 280 ± 10 280 ± 10
Student Guide HS-50 Advanced II 07/2002 Edition
9 Z-Axis
13
0HFKDQLFDOVHWWLQJV
%HOW7HQVLRQRIWKH=$[LV
➠
Attach the measuring head in front of the toothed belt.
NOTE
The measuring point of the measuring pin must be in the middle of the two deflection pulleys.
The measuring pin should be at a maximum distance of 2 - 3 mm, from the toothed belt.
➠ Strike the toothed belt, to reach a stimulation of vibration of the open ended toothed belt.
➠ Stretch the belt over the fastening of the driving motor (compare: service manual) if the
frequency of the belt tension does not reach a value of 280 Hz +
10 Hz.
➠ Repeat these instructions until the belt tension is correct.
Messpunkt: Riemenmitte /
measuring point: middle of belt