ASM_MANUAL_TYPHOON_USC_en_100620_online.PDFA - 第28页
3 TYPHOON UNDER STENCIL CLEANER 3.6 REPLENISHMENT PROCEDURES 28 STANDALONE MANUAL TYPHOON UNDER STENCIL CLEANER 06/2020 6. Feed the fabric from the fabric roll over the usage reel (6), plenum chamber (7) and across the t…
3 TYPHOON UNDER STENCIL CLEANER
3.6 REPLENISHMENT PROCEDURES
STANDALONE MANUAL TYPHOON UNDER STENCIL CLEANER 06/2020 27
3.6.1.2 Fabric Roll Replacement
To install new fabric roll, carry out the following:
1. Install the fabric take-up roller (1) (without the fabric clamping spindle fitted):
– Fit the left-hand end of the fabric take-up roller.
– Push the fabric take-up roller to the left-hand side, allowing the right-hand grooved end to
line up with and connect into the paper motor drive.
– Ensure that the fabric clamping spindle slot is facing upwards.
1
2. Remove new fabric roll (3) from the packaging (2).
2
3
4
3. Fit the left-hand end of the new fabric roll onto the left-hand end sprung plunger.
4. Push the new fabric roll towards the left-hand end of the USC, until the right-hand end can
slide over the fabric roll brake. Ensure the fabric roll is loaded in the correct direction.
5. Remove all fabric roll fastening tape (4).
3 TYPHOON UNDER STENCIL CLEANER
3.6 REPLENISHMENT PROCEDURES
28 STANDALONE MANUAL TYPHOON UNDER STENCIL CLEANER 06/2020
6. Feed the fabric from the fabric roll over the usage reel (6), plenum chamber (7) and across the
top of fabric take-up roller (8) - fabric should run 10mm past fabric take-up roller.
5
68 7
7. Ensure that the fabric is running parallel with the plenum chamber, measure distance from
each end of plenum chamber to the edge of the fabric roll.
A B
A = B
8. Insert the right-hand end of the fabric clamping spindle (9) into the paper motor drive.
9
3 TYPHOON UNDER STENCIL CLEANER
3.6 REPLENISHMENT PROCEDURES
STANDALONE MANUAL TYPHOON UNDER STENCIL CLEANER 06/2020 29
9. Lower the fabric clamping spindle down into the fabric clamping spindle slot, and when in
place rotate 45° anti-clockwise using the left-hand end.
10. Rotate the fabric take-up roller two full revolutions clockwise to securely bind the fabric to the
take-up roller.
x2
11. Select Paper Roll Length.
12. Enter the length of fabric roll fitted.
13. Select Accept.
14. Select Continue.
15. Select Prime Paper.
16. Using the two machine jog buttons simultaneously, ensure the fabric feeds correctly.
17. Press the Back button.
18. If stencil was moved / removed during fabric roll removal, reposition / install stencil as re-
quired.
19. Close the printhead cover.
20. Press the System button.
21. If required, select Load Screen.
22. Select Continue.
23. Select Back.
3.6.2 Solvent
WARNING
RECOMMENDED SOLVENTS. ANY SOLVENTS USED MUST COMPLY WITH
LOCAL ENVIRONMENTAL GUIDELINES. ASM RECOMMEND USING
SOLVENTS THAT ARE ENVIRONMENTALLY FRIENDLY, IE CFC FREE AND
WATER BASED. SOLVENTS USED MUST HAVE FAST EVAPORATION RATES
AND FLASHPOINT SPECIFICATIONS GREATER THAN 39°C.
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHING SHOULD BE
WORN BY SOLDER PASTE AND SOLVENT HANDLERS AT ALL TIMES TO
ELIMINATE FUME INHALATION, EYE CONTACT, SKIN CONTACT AND
INGESTION.