00195374-0202_AI_LBO-D1D2_DE EN - 第56页

2 Assembly instructions Long board op tion SIPLACE D1 / D2 Long board option 06/2007 Edition 56 2.9 Function check : S tart the SITEST prog ram. : Check by adju sting the con veyor width whethe r the actua tors reliably …

100%1 / 70
Long board option 2 Assembly instructions Long board option SIPLACE D1 / D2
06/2007 Edition
55
2.8.2 Set-up
: Select a set-up (see picture).
: For the PCB conveyor, select "Long Board" and enter the value 150.000 under "Stopper 2 at
po
sition" for both processing areas.
Select the set-up
Enter 150.000
Select Long Board
150.000 150.000
2
2
2
The stopper position is not included in the optimization unless the "Use for optimization" box is
checked. 2
2
2
2
2
2 Assembly instructions Long board option SIPLACE D1 / D2 Long board option
06/2007 Edition
56
2.9 Function check
: Start the SITEST program.
: Check by adjusting the conveyor width whether the actua
tors reliably actuate the switches on
the units.
If this is not the case, readjust the affected actuators or units.
2
Teaching the sonar sensor 2
: Place a PCB on the conveyor.
: Push the PCB towards the processing area so that it is beneath the sensor.
: Hold down the button until the LED flashes (see photograph below).
Wh
en teach
ing mode starts, the LED lights up constantly while the PCB
remains in position.
Button
LED
2
2
: Remove the PCB from the conveyor and place it sideways across the conveyor side walls
above the sensor.
The LED must not light up; the LED must only light up if th
ere is a PCB on the conveyor.
2
Long board option 2 Assembly instructions Long board option SIPLACE D1 / D2
06/2007 Edition
57
2.10 Conversion for LBO on the flexible dual conveyor
in single conveyor mode
To be able to produce long boards > 460 x 216 mm wide on the dual conveyor, the flexible dual
conveyor must be selected in SIPLACE Pro for the entire line. 2
: Shut down the station computer and switch off the place
ment machine at the main switch.
: Unplug the connecting cable and remove the hose with
the quick-release coupling on the stop-
per on the conveyor.
: Remove both the long board stopper and the actuator fo
r the width adjustment limit switch.
Coupling
Plug
2
2
: Optimize the set-up with this line (flexible dual conveyor, long board) and an initial set-up in
which the long board option is entered with an offset.
: Assign this job to the line.