PS288_OwnersMnl_PriorTo2009 - 第205页

Appendix A A-2 PS288 Owner’s Manual

PS288 Owner’s Manual A-1

AAppendix A

I/O Controller LED Status

Appendix A

A-2 PS288 Owner’s Manual

Appendix A

PS288 Owner’s Manual A-3

ON = LED turned On (i.e. lit green) - indicates logical bit value of 0 (zero).

Input Ports - Sensor signals coming into the I/O Controller (as sensed by I/O Controller)

Port-1

Bit-0 PNP Head Vacuum Sensor. ON = sensed device on pickup tip.

Bit-1 Socket Opener - UP. ON = Socket Opener is in the UP position

Bit-2 Socket Opener - down. ON = Socket Opener down, socket is pressed open.

Bit-3 Tray #1 Present. ON = Tray-1 Present - OR Tray Feeder #1 READY

Bit-4 Tray #2 Present. ON = Tray-2 Present - OR Tray Feeder #2 READY

Bit-5 Tray #3 Present. ON = Tray-3 Present

Bit-6 Safety Shield/Door Interlocks. ON = Doors Closed, OFF = Door Open. Machine will NOT run.

Bit-7 Not Used

Port-2

Bit-0 ON = Auto Tray Feeder #1 ERROR-1

Bit-1 ON = Auto Tray Feeder #1 ERROR-2

Bit-2 ON = Auto Tray Feeder #2 ERROR-1

Bit-3 ON = Auto Tray Feeder #2 ERROR-2

Bit-4 Not Used

Bit-5 ON = Device present on Cup#2, Laser Vacuum Sensor -SV14, Cup#2 on Laser Transfer Shuttle.

Bit-6 Labeler Sensor

Bit-7 ON = Device present on Cup#1, Laser Vacuum Sensor -SV12, Cup#1 on Laser Transfer Shuttle.

Port-3

Bit-0 ON = Input Shutter Piston, Open - Shutter should NOT be covering Laser Bay

Bit-1 ON = Input Shutter Piston, Closed - Shutter should be covering Laser Bay

Bit-2 Label Sensor - Limited Use, only on some units

Bit-3 Ink Marker Door Closed - Limited Use, only on some units

Bit-4 Labeler (Apollo) Finished Marking. 0 = On Not Ready, 1 = Off = Ready for Marking

Bit-5 ON = Output Shutter @ Tape Out Unit Closed

Bit-6 ON = Output Tape Ready. (V-Tek) Taping unit Ready

Bit-7 ON = Output Tape Error, could be due to one of the 5 sensors on the Tape-Out Unit

Port-4

Bit-0 ON = Input Shutter Closed - Door Sensor. Door Closed and sensed by Opto Sensor on side.

Bit-1 Air Flow Sensor for FUMEX filter. ON indicates insufficient air flow -> Replace Filter(s)

Bit-2 Laser System Ready. ON indicates Device under Laser Head and ready to be marked

Bit-3 Not Used

Bit-4 Not Used

Bit-5 Not Used

Bit-6 Not Used

Bit-7 Laser Done Marking. O =On, Laser has finished marking the device. Device ready to proceed.

I/O Controller LED Status - by Port Number

I/O Controller LED Status: Input Ports