Apollo1_Operators_Manuel - 第52页
52 cab - Produkttechnik GmbH / Tharo Systems, Inc. The following table shows the specific settings for the date format and the time format of all countries available. Date Time Land Deutschland 29.12.1996 20:15:56 Pays F…
51cab - Produkttechnik GmbH / Tharo Systems, Inc.
Country/Land
The Parameter "Country" (or "Land") allows the LCD display language to be
set, which also dictates the format of date and time used for the printer display
as well as for printing.
The formats of date and time used for the printout can be altered via software.
The language that the prompts on the LCD are displayed in cannot be altered
through software, only with the front panel.
Default Setting : USA
2 Transfer print
Fig. 9 b Set "Country" parameter
18
Pause reprint
1 Country
Selection
xxxx
xxxxxxxxx Yes
xxxx
xxxxxxxxx No
Confirmation
Land
Deutschland
Pays
France
Country
United Kingdom
Country
USA
Pays
Suisse
Pays
Belgie
Maa
Suomi
Nazione
Italia
Pais
España
Land
Schweiz
52 cab - Produkttechnik GmbH / Tharo Systems, Inc.
The following table shows the specific settings for the date format and
the time format of all countries available.
Date Time
Land
Deutschland 29.12.1996 20:15:56
Pays
France 29.12.1996 20:15:56
Country
United Kingdom 29/12/1996 20:15:56
Country
USA 12-29-1996 08:15:56 pm
Land
Schweiz 29.12.1996 20,15,56
Pays
Suisse 29.12.1996 20,15,56
Pays
Belgie 29/12/1996 20:15:56
Maa
Suomi 29.12.1996 20:15:56
Nazione
Italia 29-12-1996 20:15:56
Pais
España 29-12-1996 20:15:56
Table 9 Specific format settings for date and time
53cab - Produkttechnik GmbH / Tharo Systems, Inc.
Transfer Print
The parameter "Transfer print" is used to set the Apollo to the print mode, either
direct thermal printing or thermal transfer printing.
This setting has an influence on two factors. On one hand, in thermal transfer
mode the printer works at a lower heat level compared to the direct thermal
printing mode. On the other hand, the ribbon sensor is only active in thermal
transfer printing mode.
This parameters can also be changed via software. For different print jobs it is
recommended that you carry out all changes in the software.
Default Setting : Transfer print ON
Transfer print
On
Transfer print
Off
Transfer print
xxx Ye s
Transfer print
xxx No
Selection
Confirmation
Fig. 9 c Set "Transfer print" parameter
F
1 Country
2 Transfer print
3 Label sensor