Apollo1_Operators_Manuel - 第68页
68 cab - Produkttechnik GmbH / Tharo Systems, Inc. T ear-off Position If the "T ear-off position" is active, an additional feed forwards will take place after completion of the print job. This makes it possible…
67cab - Produkttechnik GmbH / Tharo Systems, Inc.
Debug Mode
The "Debug mode" represents a tool for the firmware programmer.
It will help to recognize faults and their possible sources beyond standard error
messages.
For standard use of the printer, the parameter should always be switched OFF.
Default Setting : Debug mode OFF
Debug mode
Off
Debug mode
On
Debug mode
xxx Ye s
Debug mode
xxx No
Selection
Confirmation
Fig. 9 r Set "Debug mode"
15 Backfeed
16 Debug mode
17 Tear-off positio
68 cab - Produkttechnik GmbH / Tharo Systems, Inc.
Tear-off Position
If the "Tear-off position" is active, an additional feed forwards will take place
after completion of the print job. This makes it possible to cut off the last label
at the tear-off plate. After starting a new print job, first the label material will be
fed back until the front edge of the first label is located at the print line.
If the parameter is OFF, the label dispense stops immediately after the last
label has completely passed the print line.
Default Setting : Tear-off position OFF
Tear-off positio
On
Tear-off positio
xxx Ye s
Tear-off positio
xxx No
Selection
Confirmation
Fig. 9 s Set "Tear-off position" parameter
16 Debug mode
17 Tear-off positio
18
Pause reprint
Tear-off positio
Off
69cab - Produkttechnik GmbH / Tharo Systems, Inc.