DECAN_S1_Administrator′s_Guide(Eng_Ver1.5)_Print.pdf - 第189页

7-25 Part Registration 7.1.1. Common Align Data Provides details con cerni ng the align data common ly applied to all parts.  <Camera No.> combo box  Fly Cam: Selects the fly camera of the head . Memo The fly cam…

7-24

Next Generation, Multi-Functional Placer DECAN S1 Administrator’s Guide

 <Emboss> check box

Check whether the reel type of the feeder to feed the part being edited is

“Emboss”. Whether this check box is ticked depends on whether the “Auto

Apply Pick Up Height” function is applied. For details, refer to “14.4.1.

<Auto Apply Pick Up Height> check box” in the <General> tab dialog box.

7-25

Part Registration

7.1.1. Common Align Data

Provides details concerning the align data commonly applied to all parts.

 <Camera No.> combo box

 Fly Cam: Selects the fly camera of the head.

Memo The fly camera for recognizing each head is as follows:

 Fly Cam1: Head #1~Head #2 of the front gantry

 Fly Cam2: Head #3~Head #4 of the front gantry

 Fly Cam3: Head #5~Head #6 of the front gantry

 Fly Cam4: Head #7~Head #8 of the front gantry

 Fly Cam5: Head #9~Head #10 of the front gantry

 Fix Cam1: Select the fix camera.

 button

Sets the lighting for the camera to recognize the component. When this button is

clicked on, the following dialog box is displayed.

Figure7.7 “Camera No. =Fly Camera“ dialog box

7-26

Next Generation, Multi-Functional Placer DECAN S1 Administrator’s Guide

Figure7.8 “Camera No. =Fix Camera“ dialog box

 <Side> slide bar

Set a value for the side light. (0 –15)

 <Outer> slide bar

Set a value for the outer light. (0 - 15)

 <Inner> slide bar

Set a value for the outer light. (0 - 15)

 <OK> button

Saves the set light value and closes the dialog box.

 <Cancel> button

Closes the dialog box without saving the set light value.

Table7.1 Use of the Fix Camera Lighting

 <Size> group

 <Align Z> edit box

Set the height for recognition. Based on the component surface, if the top is to be

recognized, set - value, and if the bottom is to be recognized, set +value.

 <Threshold> edit box

The image viewed through the SM Vision window is composed of each pixel.

Each pixel has a unique value between 0 and 255 according to the seen degree of

brightness. Here, ‘Threshold Value’ indicates the border value deciding whether

Light Use Applicable Part Remarks

Side Lights the edge of a part Chip, QFP, BGA, SOP etc

Outer Lights round edge of a

part or part surface

Chip, QFP, BGA, SOP etc

Inner Lights a part surface Chip, QFP, BGA, SOP etc