N7201A617E00_0317 - 第128页
NPM-W 2 EJM7DE-MB-03 M-00 Detaching the feeder table cover 3-3 -1 5 Allen wrench (3 mm) Loosen the feeder table cover screws 6 Remove the feeder table cover 1 3 4 Feeder c over Pull out the feeder cart ( → P.3-2) Mainten…
NPM-W2 EJM7DE-MB-03M-00
3-2-2
Pull the pipe up
Press for over
three seconds
(The cart is secured to the
machine as the buzzer
sounds, and the lamp
changes from flashing to
illumination)
Attach the feeder cart
How to attach
(The lamp changing from
illumination to flashing
allows you to attach the
cart to the main body)
Put the handle back
Put the handle back
*Be careful not to pinch the
feeder power cable in any
place as you set the cart.
*Be careful not to pinch the feeder power cable in any
place as you put the handle back.
1 2
1
2
3
Periodic
inspection
●One on either side
NPM-W2 EJM7DE-MB-03M-00
Detaching the feeder table cover
3-3-1
5
Allen wrench
(3 mm)
Loosen the feeder table cover screws
6
Remove the
feeder table
cover
1 3
4
Feeder cover
Pull out the
feeder cart
(→P.3-2)
Maintenance
3-3
Detaching and attaching
the feeder table cover 1
OFF
SERVO
2
Push the X-axis
inward
(One on either side)
●For the machine that the independent changeover support unit
(movable cover) is installed, the insertion way of the wrench is
different from the one shown in the picture above step ⑤.
NPM-W2 EJM7DE-MB-03M-00
Attaching the feeder table cover 1
4
Place the feeder table cover
Feeder table cover
Guide
Guide
To
7
3-3-2
5
Secure the
feeder table
cover
Allen
wrench
(3 mm)
Safety switch
Make sure the key of feeder
table cover is inserted into the
safety switch
Periodic
inspection
OFF
SERVO
1
3
2
Push the X-axis
inward
6
(One on either side)
Allen
wrench
(3 mm)
Check fitting of the safety switch of the
feeder table cover