N7201A617E00_0317 - 第169页

NPM-W 2 EJM7DE-MB-05 M-00 5-3-2 -4 Every 140 hours Periodic Periodic Periodic inspection To 16 Fold the feeder table cover to the back Cover the multi- recognition camera with a lint free cloth OFF SERVO 4 6 5 7 8 PCB-su…

100%1 / 572
NPM-W2 EJM7DE-MB-05M-00
5-3-2-3
ENABLING
1
ENABLING
2
3
Confirm the
message
Detach the
feeder cart
(→P.3-2)
Front side
(X-axes in the front and
rear move to the retraction
position)
Cleaning
the PCB-
support
blocks
Cleaning the PCB-support
blocks
(dual conveyor specifications) 2
Maintenance
5-3-2
9
Clean the PCB holder and the PCB-support
block
●Use a lint free cloth or brush.
●Clean the top surface of the
PCB support block (for
automatic change) with a lint
free cloth dampened with
alcohol.
●Be careful not to scratch
coating material on the
surface of the PCB support
block (for automatic change)
by sharps.
10
Attach the PCB-
support block as
it is no tilt
●PCB-support block
：4 blocks
PCB-support block
Guide pin
12
11
Return the feeder
table cover back
Remove the lint
free cloth
●If it tilts, it interferes with
the rail.
NPM-W2 EJM7DE-MB-05M-00
5-3-2-4
Every
140
hours
PeriodicPeriodicPeriodic
inspection
To
16
Fold the feeder
table cover to
the back
Cover the multi-
recognition
camera with a
lint free cloth
OFF
SERVO
4
6
5
7
8
PCB-support block
Remove the PCB-support block
●PCB-support block：4 blocks
●Be careful not to drop an
object on the multi-recognition
camera or bump the multi-
recognition camera.
●If there are support pins on
the PCB-support block, be
careful not to fall them.
SERVO
ON
14
15
13
Attach the feeder
cart (→P.3-2)
Front side
●Neither lean against the
feeder table cover nor place
anything on it.
NPM-W2 EJM7DE-MB-05M-00
5-3-2-5
Cleaning
the PCB-
support
blocks
Maintenance
5-3-2
Cleaning the PCB-support
blocks
(dual conveyor specifications) 3
ENABLING
16
17
ENABLING
Confirm the
message
●When you clean the PCB-support block, please check the support pin condition. If flux is adhered to the tip
of the support pin, wipe off with a lint free cloth.
NOTICE
●Do not apply impact such as dropping on the support pin for automatic change. It may cause deformation.
Do not use a deformed support pin.
●Please note that the vacuum hole of the support pin for automatic change is not clogged.
ATTENSION
Vacuum hole