N7201A617E00_0317 - 第185页

NPM-W 2 EJM7DE-MB-06M-00 6-2 -4 To 12 Every 560 hours Periodic Periodic Periodic Periodic inspection 10 Wipe any excess grease off ● Wipe any excess grease off from X-and Y-axis linear guides or adhered grease out of tra…

100%1 / 572
NPM-W2 EJM7DE-MB-06M-00
6-2-3
Greasing the XY-axis
linear guide 2
Maintenance
6-2
8
Apply grease to the Y-axis linear guide
●Apply grease to both top and bottom grease nipples in the
following steps.
①Give one half pump (about 0.5 cm
3
)
②Move the Y-axis about 100mm.
③Give one half pump (about 0.5 cm
3
)
●Grease: LG100
Linear guide grease nipple
●Top and bottom grease nipples
●Top and bottom grease
nipples
Move the X- and Y-
axis several times
●Move them along the
entire stroke to disperse
the grease throughout the
linear guides.
9
NPM-W2 EJM7DE-MB-06M-00
6-2-4
To
12
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection
10
Wipe any excess grease off
●Wipe any excess grease off from X-and Y-axis linear guides or adhered grease out of travel
surfaces.
Grease squeezed out
Y-axis linear guide
●Visually check the installation hole in the linear guide rail from the opposite axis, and wipe off
excess grease, if any.
Installation hole in the
linear-guide rail
Grease squeezed out Excess grease
X-axis linear guide
11
Check the grease sumps
●Wipe off any grease squeezed out.
Grease sump under Y-axis
(left)
Grease sump under Y-axis
(Right)
Grease sump under X-axis
NPM-W2 EJM7DE-MB-06M-00
Select X-axis
Select Y-axis
(Front and rear)
Greasing the XY-axis
linear guide 3
6-2-5
Maintenance
6-2
21
22
23
24
25
26
ENABLING
10 shuttle
Select a table
STOP
12
SERVO
ON
13 14
Detach the
feeder cart
(→P.3-2)
ENABLING
10 shuttle