N7201A617E00_0317 - 第221页
NPM-W 2 EJM7DE-MB-06M-00 6-12 -2 Every 560 hours Periodic Periodic Periodic Periodic inspection
NPM-W2 EJM7DE-MB-06M-00
1
2
Wipe dust off the surface of the conveyor belt and around the perimeter of
the components detection sensor
Cleaning the components-
ejection conveyor
(option)
Describes how to clean the components-ejection conveyor.
Tool used: Lint free cloth Time required: 2 minutes
Install the components-ejection conveyor to the feeder cart that has been
disconnected from the machine, or to the feeder pedestal
●Use a lint free cloth
●It is also acceptable to disconnect from the machine the feeder cart that has been installed
with the components-ejection conveyor.
Conveyor belt
Components
detection sensor
6-12-1
●When handling the components-ejection conveyor, be careful not to hit the roller on the end.
Maintenance
6-12
NPM-W2 EJM7DE-MB-06M-00
6-12-2
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection
NPM-W2 EJM7DE-MB-06M-00
This section explains the procedure for a single tray feeder. Follow the same procedure for a twin tray feeder.
Tool used: Grease gun Time required: 20 minutes for a single tray feeder, 40 minutes for a twin tray
feeder
Greasing to the tray
feeder
(option) 1
6-13-1
Maintenance
6-13
OFF
SERVO
OFF
SERVO
SERVO
ON
7
8
1
2
3
9
11
10
For a twin tray
feeder, select a
table
or
ENABLING
(The tray feeder drawer
moves to the maintenance
position.)
ENABLING
Open the magazine
cover and remove the
upper magazine
(→[Operating procedure]
P.2-4-2)
Push the X-axis
inward