N7201A617E00_0317 - 第224页

NPM-W 2 EJM7DE-MB-06 M-00 Gr easing to the tr ay f e eder (option) 2 6-13 -3 12 Apply grease to each point of the tray feeder drawer ● For a twin tray, A and B Linear guide (right and left) Inside of cam block (left) Fro…

100%1 / 572
NPM-W2 EJM7DE-MB-06M-00
To
12
6-13-2
4
5
6
Apply grease via grease nipples to the
vertical-axis ball screw and the linear guide for
the lifter
Ball screw
Grease nipple
●Apply grease via grease nipples
with a grease gun.
Give two pumps for each
(Approx. 1.8 cm
3
)
●Grease: LCG100
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection
NPM-W2 EJM7DE-MB-06M-00
Greasing to the tray
feeder
(option) 2
6-13-3
12
Apply grease to each point of the tray feeder drawer
●For a twin tray, A and B
Linear guide
(right and left)
Inside of cam block (left)
Front
●Greasing points
・Linear guide rails (right and left)
・Inside of cam blocks (right and left)
●Grease: LCG100
Inside of cam block (right)
18
ENABLING
19
Have it run for about a
minute, and then
Maintenance
6-13
SERVO
ON
17
NPM-W2 EJM7DE-MB-06M-00
14
15
16
Place the
magazines back in
place and close
the magazine
cover
(→[Operating procedure]
P.2-4-2)
Drawer-axis
13
Pull drawer-axis of the tray feeder upper
surface toward you
●As the drawer is around the
magazine door, pull it toward you
as below.
Drawer
-axis
Apply grease to each part of the tray
feeder drawer
●Greasing points
・Linear guide (right and left)
・Inside of cam plates (right and left)
●Grease: LCG100
Place the drawer
back as its
original position
Drawer-axis
●For a twin tray, A and B
Linear guide
Drawer-axis
Cam plate
Drawer-axis
Greasing area
6-13-4
Front
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection