N7201A617E00_0317 - 第229页
NPM-W 2 EJM7DE-MB-06M-00 6-16 -2 Every 560 hours Periodic Periodic Periodic Periodic inspection
NPM-W2 EJM7DE-MB-06M-00
Inspecting the air drain
(regulator unit)
Describes how to inspect an air drain of the regulator unit.
Tool used: Lint free cloth, Allen wrench (2.5 mm) Time required: 5 minutes
2
Remove the lower-right cover located on the
rear of the machine to check for any water
accumulated in the air drain
●No water should accumulate in
the air drain under the
environmental conditions
specified by us.
NOTIICE
If water is accumulated in the air drain
3 4
Disconnect
the air hose
Drain the water out of the air drain
①Place a water-receiving bottle
(prepare on your own) under
the drain cock.
②Press the drain cock button to
drain water.
5
Connect the
air hose
●Wipe off any excess
moisture with a lint free cloth.
6
Close the
lower-right
cover on the
rear of the
machine
Air drain
Drain cock
button
6-16-1
●For machines operated under
environmental conditions other
than those specified by us,
periodically check the air drain
and drain water from it, if any.
Loosen the bolt
(using an Allen
wrench)
●Two locations
Tighten the bolt
(using an Allen
wrench)
●Two locations
Maintenance
6-16
4
1
Turn OFF the
power and lock
the machine
OFF
NPM-W2 EJM7DE-MB-06M-00
6-16-2
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection
NPM-W2 EJM7DE-MB-06M-00
Attach the
feeder cart
(→P.3-2)
Greasing the cutting
unit
6-17-1
Tool used: Grease gun Time required: 3 minutes
1
2
Apply grease to the linear guides, bearings and guide blocks
●Apply grease via the grease nipple. (three locations)
・Linear guide
・Bearing
・Guide block
(Use the grease gun. About 0.9 cm
3
per pump)
●Grease: LCG100
3
Detach the feeder
cart
(→P.3-2)
Grease nipple
Feeder cart (option)
Grease nipple
Grease nipple
Front
Right side
Right side greasing point
Maintenance
6-17