N7201A617E00_0317 - 第276页

NPM-W 2 EJM7DE-MB-08M-00 8-5 Maintenance 8-5 This adjustment is performed for an inspection hea d. The inspection hea d judges an inspec tion result by using colors and bright ness of images capture d by the color camera…

100%1 / 572
NPM-W2 EJM7DE-MB-08M-00
Upper collars
8-4-2
Replacing the upper collar
1
2
Loosen the screws to detach the propeller
Screws
Propeller
Loosen the upper
cap to detach it
(turn in a
clockwise
direction)
●If it is difficult to remove the
propeller, hold the center of the
screw shaft with the pliers and
disassemble it.
3
Draw out the
screw shaft
about 10 mm of
the screw unit
Upper cap
4
Replace the two
upper collars
●There is no difference
between front and rear
sides.
5
Put the screw unit back together again
●Tighten the upper cap (turn in a
counterclockwise direction), fix the screw shaft,
and attach the propeller.
●When the markings are aligned, tighten the
screws.
Be careful not to leave any clearance .
Marking
●There is no problem if the center
of the screw shaft is scathed.
Upper cap
Every
3000
hours
PeriodicPeriodicPeriodicPeriodicPeriodic
inspection
NPM-W2 EJM7DE-MB-08M-00
8-5
Maintenance
8-5
This adjustment is performed for an inspection head.
The inspection head judges an inspection result by using colors and brightness of images captured by the
color camera.
Adjustment of white balance is a function to calibrate the camera to the normal condition so that the
inspection head can perform inspection correctly.
The calibration board and user master board are used for adjusting white balance. On the machine side,
colors and brightness of the camera is calibrated by using the calibration board. Because colors and
brightness of the calibration board itself change due to such as dust on the surface or deterioration with age,
it can also be calibrated by the user master board.
Therefore, when you adjust white balance, a target value of the calibration board must be obtained as well.
This operation is performed only on the inspection head.
●Detailed information and procedure for adjustment (→P.13-13 ‘White balance (2D inspection head)’)
Adjusting white
balance
(2D inspection head(option))
9 Periodic inspection
Every-6000-hours