N7201A617E00_0317 - 第353页

NPM-W 2 EJM7DE-MB-13M-00 13-2 -2 Confirm the message 6 6 ● When you do not save the data ● To cancel (The screen remains as it is in . ) 5 Confirm the message 7 (XY unit moves to the origin) + 7 Confirm that it has been …

100%1 / 572
NPM-W2 EJM7DE-MB-13M-00
Choose a table
●Choose the table to calibrate.
2
+
1
Head camera XY origin
Explains the method for calibrating the head camera’s XY origin, taking for an example, the 12-nozzle head;
however, the same method can also be applied to the light weight 16-, 8-, and 3-nozzle heads.
You must operate the machine under the pre-operation status in the following environmental conditions;
temperature: 10 to 35 ℃ and humidity: 25 to 75 % RH.
(The camera angle is calibrated)
Confirm that it has been
successfully completed
+
(The XY origin camera scale is
calibrated)
12
3
13-2-1
3
Maintenance
13-2
NPM-W2 EJM7DE-MB-13M-00
13-2-2
Confirm the message
6
6
●When you do not save the data
●To cancel
(The screen remains as it is in . )
5
Confirm the message
7
(XY unit moves to the origin)
+
7
Confirm that it has been
successfully completed
4 5
4
5
●Perform steps to for the
other table.
1
4
Calibration
NPM-W2 EJM7DE-MB-13M-00
+
1
Plane correction XY 1
Explains the method for calibrating the plane correction XY, taking for an example, the 12-nozzle head;
however, the same method can also be applied to the light weight 16-, 8-, and 3-nozzle heads. For the
inspection head (→P.13-17-1)
●For dual conveyor specifications, perform calibration in single lane mode. (→P.11-3)
●Place the plane correction jig on the transfer conveyor to the left or right of the machine by hand and
operate it. (One plane correction jig: N210147296AB)
●Do not turn OFF the power of the machine during calibration.
●Remove all the PCB support pins before performing plane correction.
●Calibrate it at the front to enhance workability.
Check that there are no PCBs
present inside the machine
●If ‘error’ message appears, remove all
the PCBs remaining inside the machine,
and try again.
1
13-3-1
(The width is adjusted)
(The head moves to the retraction
position.)
Maintenance
13-3
2
Prepare for the first plane
correction XY
4
3
Open the safety cover
Servo switch OFF