N7201A617E00_0317 - 第373页

NPM-W 2 EJM7DE-MB-13M-00 13-6 -2 Calibration (Calibration is carried out) + Confirm the message Servo switch ON Confirm that it has been successfully completed + Confirm that it has been successfully completed 9 8 10 12 …

100%1 / 572
NPM-W2 EJM7DE-MB-13M-00
1
Placement position/
Conveyor 1
13-6-1
This operation procedure is also shared by the light weight 16-, 12-, 8-, 3-nozzle heads, and dispensing heads.
Maintenance
13-6
●For selecting a calibration target head , the head installed at the front side has a priority.
In NPM-W2, calibration is not performed by the dispensing head on the rear side.
If either placement head or dispensing head is installed to the front side, calibration is performed at the
front side. If neither placement head nor dispensing head is installed to the front side, but only the
placement head is installed to the rear side, calibration is performed at the rear side.
●For the dispensing head, the screw being set the calibration nozzle (No. 7202) must be installed to the
dispensing head in advance, and refill adhesives during ejection check. (→[Operating procedure] P.3-4)
Also before calibration is performed, ensure that no adhesive adheres to the nozzle tip.
1
2
2
+
(The head moves to the work position)
Prepare to install nozzles
Open the safety cover
Install nozzles
●Nozzle used
Head
type
Nozzle
position
Nozzle
type
16 No. 5
230CS
12 No. 4
8 No. 3 230C
3No. 21002
Close the safety cover
●For the dispensing head, it is necessary
to install the screw unit that a calibration
nozzle (nozzle no. 7202) is previously
set to the nozzle position 2.
Servo switch OFF
3
4
5
6
7
NPM-W2 EJM7DE-MB-13M-00
13-6-2
Calibration
(Calibration is carried out)
+
Confirm the message
Servo switch ON
Confirm that it has been
successfully completed
+
Confirm that it has been
successfully completed
9
8
10
12
17
12
10
11
(The head moves to the work position
and measure height)
Confirm that it has been
successfully completed
+
11
(The head moves to the work position
and measure the stop position)
NPM-W2 EJM7DE-MB-13M-00
13-6-3
Placement position/
Conveyor 2
Maintenance
13-6
Confirm the message
(The height and the stop position
measurement data is saved)
●When you do not save the data
●To cancel
(The screen remains as it is in )
Open the safety cover
Remove nozzles
Prepare to remove nozzles
Close the safety cover
Servo switch OFF
Servo switch ON
13
17
18
19
14
15
16
12
13
(The head moves to the work position)