N7201A617E00_0317 - 第424页
NPM-W 2 EJM7DE-MB-13M-00 13-12 -3 Maintenance 13-12 Dispensing head 2 11 + 11 13 14 Open the safety cover 12 18 + Confirm the message 18 15 16 17 Remove nozzles Close the safety cover 19 + Confirm the message 19 Confirm …
NPM-W2 EJM7DE-MB-13M-00
Confirm that it has been
successfully completed, and
choose the other head
positions for plane correction
Z and then repeat steps from
to .
7
Confirm that it has been
successfully completed
+
8
3 7
9
13-12-2
(Calibration is carried out)
(The confirmation scree of data save
appears)
7
8
9
10
Confirm the message
7
10
(The data obtained by calibration is
saved)
Calibration
NPM-W2 EJM7DE-MB-13M-00
13-12-3
Maintenance
13-12
Dispensing head 2
11
+
11
13
14
Open the safety cover
12
18
+
Confirm the message
18
15
16
17
Remove nozzles
Close the safety cover
19
+
Confirm the message
19
Confirm the message
(The head moves to the work position)
Prepare to remove nozzles
Servo switch ON
Servo switch OFF
NPM-W2 EJM7DE-MB-13M-00
13-12-4
Calibration might not be performed properly due to material characteristics. Follow the procedure below.
1
A
2
3
■When adhesive other than recommended (ADE820DX, ADE850D) is used
1
A
2 3
Updates the value for calibration by using
the set value in the ‘Action setting’.
Exits the condition check window.
Action setting
Change the settings of [Dispenser time
(s)], [Temperature (℃)] and [Pressure
(MPa)] based on the adhesive to use.
●If the dispensing diameter is longer
Time: Set to shorter
Temperature: Set to lower
Pressure: Set to lower
●If dispensing diameter is shorter
Time: Set to longer
Temperature: Set to higher
Pressure: Set to higher
Calibration