N7201A617E00_0317 - 第70页
NPM-W 2 EJM7DE-SF-01N-0 0 Com- ponent names Oper a t ion s witch 1-9-2 -1 1-9-2 ST AR T Starts pr oduction. ● Restarts productio n when in temporary s top. ● Push the button with at the same time Front and rear sides
NPM-W2 EJM7DE-SF-01N-00
1-9-1-2
Operating units
Signal tower
Red: Illuminates when you push emergency stop switch or in case
of error stop.
Yellow: Illuminates in case of material shortage.
Green: Illuminates in automatic operation.
Red: Illuminates when you push emergency stop switch or in case
of error stop.
●You can change the above setting. (→ [Operation Edition P.7-1-3)
●Please refer to the [Operating Procedure] (→ P.7-2-4)
●The signal tower is placed sideways when shipped , however the angle can be adjusted.
Front and
rear sides
Confirmation
Emergency stop
switch
Stops operation
immediately
Main power supply
switch (Front side)
Turns ON/OFF the power and
air supply.(When you turn off
the power supply switch, the
air supply is shut off also.)
Various operation
switches
Controls operation start /
stop.
Access lamp
(Green LED)
SD card reader
Reading and writing of
programming data.
Servo switch
Turns ON/OFF the
power of servo units.
NPM-W2 EJM7DE-SF-01N-00
Com-
ponent
names
Operation switch
1-9-2-1
1-9-2
START
Starts production.
●Restarts production when in
temporary stop.
●Push the button with
at the same time
Front and
rear sides
NPM-W2 EJM7DE-SF-01N-00
1-9-2-2
Emergency
stop state
Released
state
SELECT
To enable the operation switch
in front or rear, and the
touchscreen operation.
●The light is on if it is enabled.
ENABLING
Holding down the switch,
press the touchscreen’s
operation button or the switch
to operate the machine.
(For risk prevention)
STOP
To suspend production (single
stop) or to stop operations
accompanied by action.
Emergency stop switch
Stops the machine immediately
●Turn it clockwise and return it
to the original position to
release.
(Total 2 switches in front and
rear)
OPTION
Backup used in adding
functions.
●Not in use for the standard.
EXCHANGE
To install/remove feeder carts.
●The light is on if it is
replaceable.
SERVO switch
Turns ON / OFF the motor
power supply.
（Conversion to disable
machine operation commands)
●Turns on when you start
production.
●Be sure to turn off before
placing your hands into the
moving parts of the machine.
Confirmation