Mr. JF Sun ALL syringe_IPS.pdf - 第171页

Edition 4.0 H08M(Q) Head Repair T raining T ext FK-9F98-86-0E 5-7 FUJI MACHINE MFG . CO., L TD. 5.5 Adjusting the camera ins t allati on position 1. Press the lower button to return to “ADJ MODE”. 2. Use Equipment Check …

100%1 / 180
Edition 4.0 H08M(Q) Head Repair Training Text
FK-9F98-86-0E 5-6 FUJI MACHINE MFG. CO., LTD.
4. Press the upper button to select “IPS TYPE” and “HARD TYPE”, and then press the
lower button to save the settings. The settings differ depending on the IPS board, so
be careful to make the correct settings.
IPS Type Hard type IPS Board Head Type
1
1 FH1335B0F (Old) H08Q
H12SQ
5 FH1335C1F (New)
2
2
FH1406A1F (Old) H12HSQ
FH1374A0F (Old) V12
6
FH1335C1F (New) H12HSQ
FH1374B0F (New) V12
4
FH1374A0F (Old)
H08MQ
8 FH1374B0F (New)
3
3 FH1407A0F (Old) G04Q
(rev1)
7 FH1335C1F (New)
9 FH1407A0F (Old) G04Q
(rev2)
10 FH1335C1F (New)
Note: The difference between old and new boards is the difference between the LED
drivers on the IPS main board.
Note: FH1406A0F, FH1407A0F and FH1335B0F are identical.
5. The head must be rebooted after making the settings.
CONFIDENTIAL
Edition 4.0 H08M(Q) Head Repair Training Text
FK-9F98-86-0E 5-7 FUJI MACHINE MFG. CO., LTD.
5.5 Adjusting the camera installation position
1. Press the lower button to return to “ADJ MODE”.
2. Use Equipment Check to turn the following I/Os ON.
Y10C Lower Transport Height Command
Y10D Lower IPS Back Command
3. Press the lower button to enter “ADJUSTMENT 1” mode.
CONFIDENTIAL
Edition 4.0 H08M(Q) Head Repair Training Text
FK-9F98-86-0E 5-8 FUJI MACHINE MFG. CO., LTD.
4. Use Motion Tool Mini to check that the A holder is at the front of the head.
5. With holder A at this position, adjust the position of the camera so that the jigs on the B
and L holders match up with the green frames on the screen.
6. Loosen the following four bolts, and then adjust the distance between the IPS camera
and the jig nozzles to change the pitch of the nozzles on the screen.
7. If the image on the monitor does not move during the adjustment, return to the ADJ
MODE window and select [ADJUSTMENT 1] again.
8.
Loosen the 3 bolts and move the camera in the XY direction so the nozzles
align with the green frames on the LCD monitor. Then check that the center
values, resolution and tilt are within tolerance.
Left as viewed from
front
Right as viewed
from front
CONFIDENTIAL