N7201A653E - 第144页
NPM- TT2 EJ M1EE-MB-05M-0 3 ACTIVATION Maintenance 5-6 5-6 Describes cleaning of the table surface of the tray feeder draw er . Tool used : Lint free cloth Time required: 5 minutes ● Before c leaning it, ensure that the …
NPM-TT2 EJM1EE-MB-05M-03
5-5
OFF
SERVO
1
2
4
5
SERVO
ON
3
■13-slot feeder
■Feeder cart
●Clean the feeder installation face after removing feeders.
(A cause of deformation in the feeder cart.)
●Clean the feeder table using a vacuum cleaner or brush.
●Do not use an air blow gun in cleaning.
(A foreign body including dust could scatter inside the machine,
thus worsening placement quality, or breaking down the
machine.)
Cleaning the feeder table
(13-slot feeder, Feeder cart (option))
Describes cleaning of the feeder table.
Tool used: Vacuum cleaner, brush Time required: 15 minutes per location
Every
140
hours
PeriodicPeriodicPeriodic
inspection
Clean the feeder table
Feeder table
Maintenance
5-5
NPM-TT2 EJM1EE-MB-05M-03
ACTIVATION
Maintenance
5-6
5-6
Describes cleaning of the table surface of the tray feeder drawer.
Tool used: Lint free cloth Time required: 5 minutes
●Before cleaning it, ensure that the magazine is removable. (→P.6-13)
4
5
SERVO
ON
6
Tray feeder drawer
table surface
Clean the table surface
●Wipe off with a soft lint free cloth.
(The tray feeder drawer
moves to the maintenance
position)
1
2
OFF
SERVO
3
Cleaning the table surface
(tray feeder drawer (option))
NPM-TT2 EJM1EE-MB-05M-03
Maintenance
5-7
5-7-1
Every
140
hours
PeriodicPeriodicPeriodic
inspection
Connector
Describes checking of the connector.
Tool used: Flashlight, vacuum cleaner, brush and tweezers Time required : 15 minutes per location
●Perform checking after all intelligent feeders are removed.
(→P.2-4-1 ‘Preparation of the intelligent feeder’ in “Operating Procedure”)
●Do not use an air blow gun. Doing so may scatter dust and chips to the machine, having a bad influence.
●Also regularly check and clean intelligent feeders as well.
(→ “Intelligent feeder” operating instruction), (→ "Intelligent Stick Feeder" operating manual)
Check if a connector is not deformed or damaged, and insertion or adhesion of foreign materials
inside/outside of the connector. Use a flashlight to check inside of the connector.
If any foreign material is found, carefully remove it not to damage the connector using thin tweezers. Clean
dust with a vacuum cleaner or a brush.
Pay full attention to your surroundings and keep a safe distance
from people around you while moving the feeder cart
(Collisions with the feeder cart may result in injury.)
WARNING
●If any abnormality is found, stop using
the 13-slot feeder or feeder cart and
contact us, a sales distributor or an
agency.
Normal state
Abnormal state (cases)
13-slot feeder
Feeder cart
Checking connector
(13-slot feeder, Feeder cart (option))