N7201A653E - 第155页
EJM1EJ-MB-06 M-02 NPM-TT2 6-2 -4 7 Wipe any excess grease off ● Wipe any excess grease off from X-and Y-axis linear guid es or a dhered grea se out of travel surfaces. Greas e squeezed out Y-axis linear guide ● Visually …
EJM1EJ-MB-06M-02NPM-TT2
6-2-3
5
Apply grease to the Y-axis linear guide
●Grease: LCG100
●Apply grease to both top and bottom grease nipples in the
following steps.
①Loosen the grease gun tip, fit it onto a grease nipple, and
then tighten it while pressing it against the grease nipple.
(See Figure )
②Give one half pump. (about 0.5 cm
3
)
③Move the Y-axis 100mm with your hands.
④Repeat ② and ③ twice.
⑤Tilt the grease gun tip to reduce the internal pressure, then
loosen and remove it. (See Figure )
⑥ After greasing, wipe off the grease adhered to the grease
nipple.
Linear guide grease nipple
Move the X- and Y-
axis several times
●Move them along the
entire stroke to disperse
the grease throughout the
linear guides.
6
Greasing the XY-axis
linear guide 2
Maintenance
6-2
●Top and bottom grease
nipples
●Top and bottom grease
nipples
4
4
EJM1EJ-MB-06M-02NPM-TT2
6-2-4
7
Wipe any excess grease off
●Wipe any excess grease off from X-and Y-axis linear guides or adhered grease out of travel
surfaces.
Grease squeezed out
Y-axis linear guide
●Visually check the installation hole on the linear guide rail from the opposite axis and if grease is
contaminated, wipe it off.
Installation hole in the
linear-guide rail
Grease squeezed out Excess grease
X-axis linear guide
8
Check the grease sumps
●Wipe off any grease squeezed out.
Grease sump under Y-axis
(left)
To
9
Grease sump under Y-axis
(right)
Grease sump under X-axis
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection
EJM1EJ-MB-06M-02NPM-TT2
9
11
10
18
Select X-axis
19
Select Y-axis
21
Greasing the XY-axis
linear guide 3
6-2-5
Maintenance
6-2
22
Wipe off the grease that ran out of the edging
●See steps and .
●Check linear guide rail edge and grease nipples whether any
liquefied grease is adhered; if any has, wipe on a regular basis.
7
8
Detach the tray
feeder or the
feeder cart
●For a tray feeder
(→ P.14-8)
●For a feeder cart
(→ P.3-2)
Attach the tray
feeder or the
feeder cart
●For a tray feeder
(→ P.14-8)
●For a feeder cart
(→ P.3-2)
ACTIVATION
20
10 shuttle