N7201A653E - 第201页
EJM1EJ-MB-06 M-02 NPM-TT2 Cleaning the saf ety co v er Describes how to clean the safety cover. Tool used: Lint free cloth, clean, soft cloth Time required: 5 m inutes ● Rather than cleaning the safety cover once a month…
EJM1EJ-MB-06M-02NPM-TT2
Describes how to clean the tray feeder magazine slot.
Tool used: Lint free cloth Time required: 10 minutes
2
1
Cleaning the slot
(tray feeder magazine (option))
Check the slots
Clean the slots
6-14
Slot
Slot
●Wipe it off with a soft dry
cloth.
●Visually check whether
the slots are free from
chipping, cracks or breaks.
Lint free cloth
Maintenance
6-14
EJM1EJ-MB-06M-02NPM-TT2
Cleaning the safety
cover
Describes how to clean the safety cover.
Tool used: Lint free cloth, clean, soft cloth Time required: 5 minutes
●Rather than cleaning the safety cover once a month, clean it as needed.
1
Wipe the cover
●Because the surface of the safety cover is
susceptible to damage, be careful neither to
scratch nor generate friction.
NOTICE
6-15
Maintenance
6-15
Every
560
hours
PeriodicPeriodicPeriodicPeriodic
inspection
● If there are contaminants, such as dust,
building up on the cover, wipe them off with a
cloth soaked in water and wrung out tightly.
After cleaning, wipe off any excess water on
the cover with a dry cloth.
●Basically, wipe it with a lint free cloth or dry
cloth.
● Do not use any alcohol, thinner, cleaners (solvent), or detergents.
Otherwise, dullness, cracking or reduction of the antistatic effect will result. If a crack occurs in the
safety cover, the crack may cause its strength to decrease.
If it is fairly contaminated and cannot be cleaned with a dampened cloth, contact us.
● Do not reuse a thing, such as waste or cloth, which you used to clean other sections of the machine.
EJM1EJ-MB-06M-02NPM-TT2
Inspecting the air drain
(regulator unit)
Describes how to inspect an air drain of the regulator unit.
Tool used: Lint free cloth, Allen wrench (2.5 mm) Time required: 5 minutes
2
Remove the lower-right cover located on the
rear of the machine to check for any water
accumulated in the air drain
●No water should accumulate in
the air drain under the
environmental conditions
specified by us.
NOTIICE
If water is accumulated in the air drain
3 4
Disconnect
the air hose
Drain the water out of the air drain
①Place a water-receiving bottle
(prepare on your own) under
the drain cock.
②Press the drain cock button to
drain water.
5
Connect the
air hose
●Wipe off any excess
moisture with a lint free cloth.
6
Close the lower-
right cover on the
rear of the machine
Air drain
Drain cock
button
6-16
●For machines operated under
environmental conditions other
than those specified by us,
periodically check the air drain
and drain water from it, if any.
Loosen the bolt
(using an Allen
wrench)
● Three locations
Tighten the bolt
(using an Allen
wrench)
●Three
locations
Maintenance
6-16
4
1
Turn OFF the
power and lock
the machine
OFF