N7201A653E - 第253页

NPM- TT2 EJ M1EE-MB-11M-0 2 1 1-2-1 -2 Replacement 7 Close the safety cover Remove the PCB support block (Both lane 1 and 2) Attach the tray feeder ( → P.14-8) T urn ON the main power sw itch ON PCB support block 8 10 9 …

100%1 / 502
NPM-TT2 EJM1EE-MB-11M-02
11-2-1-1
1
1
3
+
(The message of removing the support
pin unit is displayed)
Confirm the message
2
+
2
Confirm the message
Mode
switch
Maintenance
11-2-1
Switching to the single
lane mode 1
4
Turn OFF the main
power switch
6
5
Detach the tray feeder
(→P.14-8)
Open the safety cover
Switching the mode allows you to use the machine either for single conveyor or dual conveyor. Switching
varies depending on component supply specification. Please switch the mode based on the procedure used
for each specification. In this section, we explain how to switch from dual conveyor to single conveyor.
●When lane mode is changed, the layout of the support blocks must be changed as well.
●Make sure to use the support block suitable for each lane mode; otherwise the machine does not operate
properly.
For front/rear tray feeder specification 1
(The PCB-support blocks in lanes 1
and 2 go up so that they are ready to
be removed)
OFF
3
NPM-TT2 EJM1EE-MB-11M-02
11-2-1-2
Replacement
7
Close the safety cover
Remove the PCB support block
(Both lane 1 and 2)
Attach the tray feeder
(→P.14-8)
Turn ON the main
power switch
ON
PCB support block
8
10
9
②Pull out the PCB support block.
①From the operator side, lift the right and
left levers.
Removal lever
Removal lever
●Draw it out slowly with both hands.
●Be careful not to drop a foreign body
on the Multi-recognition camera
(LED lighting) or bump it.
NPM-TT2 EJM1EE-MB-11M-02
11-2-1-3
Mode
switch
Maintenance
11-2-1
Switching to the single
lane mode 2
For front/rear tray feeder specification 2
12
13
12
+
Turn OFF the main
power switch
11
11
+
(The PCB holders lower)
Confirm the message
(The message to shut down the power
is displayed)
OFF