N7201A653E - 第291页
NPM- TT2 EJM1EE-MB -12M-04 12-4 -2 Consumable parts replacement 4 5 6 11 10 1 2 Lever Joint Swab Press the lever and pull out the joint w ith the air filter element ● 8 location s ● Be carefu l not to drop the air filter…
NPM-TT2 EJM1EE-MB-12M-04
12-4-1
Replacing the air filter
element of the placement
head (Light weight 8-nozzle head) 1
Maintenance
12-4
3
1
ACTIVATION
2
7
8
9
1
2
LeverJoint
This section describes how to replace an air filter element of the placement head (Light weight 8-nozzle head).
Tool used: None Time required: 15 minutes (per head) Lifetime (reference): 6,000 [h]
Replace the air filter element
●Handle the air filter element
with care when replacing
it.(→P.12-4
-3)
Air filter element
Joint
O-ring
●Air filter element
Part No.: N510059928AA
●Check the O-ring for any
deterioration.
If deteriorated, replace it with
a new one.
●O-ring
Part No.: N510059867AA
Press the lever
and insert the
joint with the air
filter element
●8 locations
●Be careful not to drop the
air filter element.
●Do not hold the head
camera and perform
maintenance.
OFF
SERVO
Detach the tray
feeder or the
feeder cart
●For a tray feeder
(→ P.14-8)
●For a feeder cart
(→ P.3-2)
NPM-TT2 EJM1EE-MB-12M-04
12-4-2
Consumable parts
replacement
4 5
6
11
10
1
2
LeverJoint
Swab
Press the lever
and pull out the
joint with the air
filter element
●8 locations
●Be careful not to drop the
air filter element.
●Do not hold the head
camera and perform
maintenance.
Clean inside the filter using a swab
●Do not use an air blow gun
SERVO
ON
Attach the tray
feeder or the
feeder cart
●For a tray feeder
(→ P.14-8)
●For a feeder cart
(→ P.3-2)
NPM-TT2 EJM1EE-MB-12M-04
12-4-3
Maintenance
12-4
Precaution of handling an air filter element
■Installing of an air filter
When handling an air filter element, check the followings and use if properly.
●Do not hold the air filter element vertically.
Otherwise it might be deformed, affecting
performance of the filter.
Because the outer shape of the joint (cap) installation portion is larger than
the inner diameter of the air filter element, 1 to 2mm area from the end
surface is risen. However, it does not affect product performance.
■Handling of an air filter
●Do not reuse a used air filter element. It may cause product damage or malfunction.
●If you ever install a new air filter element to the joint (cap), it will be considered as a used one. Therefore, do
not use it again.
●Be sure to install the air filter element all the way until it hits to the end surface of the joint (cap). Be careful
not to break the element during installation.
Joint (cap)
The illustration for the light weight 16-nozzle head is used here as an example; however, the same procedure
is also applicable to an air filter element for 16-, 12-, 8-, 2- 3-nozzle head.
●Hold a new air filter element as shown
below and install it to the joint (cap).
Air filter element
Replacing the air filter
element of the placement
head (Light weight 8-nozzle head) 2