N7201A653E - 第331页

NPM- TT2 EJ M1EE-MB-13M-0 2 9 Repeat steps from to until the above reference width is achieved 8 10 (The offset value is set) 2 7 ■ When you do not save offset (The screen remains as it is in ) 9 Confirm the message 7 Ad…

100%1 / 502
NPM-TT2 EJM1EE-MB-13M-02
Width adjustment
1
4
3
2
+
Open the safety cover
Measure the conveyor width
with a vernier caliper
5
6
Close the safety cover
1
13-5-1
Explains the method for calibrating the width adjustment of the transfer conveyor.
Maintenance
13-5
Servo switch OFF
Servo switch ON
(The transfer conveyor width is adjusted
to the reference with)
Reference width
PC size conveyor: 317.5 mm
M size conveyor: 260.0 mm
Standard
PC size conveyor: 318.0 to 318.2 mm
M size conveyor: 260.5 to 260.7 mm
NPM-TT2 EJM1EE-MB-13M-02
9
Repeat steps from to
until the above reference width
is achieved
8
10
(The offset value is set)
2
7
■When you do not save offset
(The screen remains as it is in )
9
Confirm the message
7
Adjust the transfer conveyor width
10
13-5-2
9
Calibration
●When pressing [Key rate], you can
change the response.
7
①Use [Key rate] to set the moving amount.
②Use to move the
conveyor.
+
●Adjust the value of “Offset” so that the
difference of the offset value and the
measured value in step
becomes 320.6mm.
(The value is displayed in “Offset”.)
4
●Adjust the value so that the measured
value in step becomes between
320.5 and 320.7 mm.
4
NPM-TT2 EJM1EE-MB-13M-02
2
1
Placement position/
Conveyor 1
13-6-1
This operation procedure is also shared by the 8- and 3-nozzle heads.
Confirm the end processing of
the conveyor
+
(Calibration is carried out)
■To cancel
(The screen stays as it is in
on P.13-5-2)
9
1 2
■When width adjustment is performed in the
pre-process
■When width adjustment is not performed
in the pre-process
Maintenance
13-6