N7201A653E - 第332页
NPM- TT2 EJ M1EE-MB-13M-0 2 2 1 Placement position/ Con v eyor 1 13-6 -1 This operation procedur e is also shared by the 8- and 3-nozzle h eads. Confirm the end processing of the conveyor + (Calibration is carried out) ■…
NPM-TT2 EJM1EE-MB-13M-02
9
Repeat steps from to
until the above reference width
is achieved
8
10
(The offset value is set)
2
7
■When you do not save offset
(The screen remains as it is in )
9
Confirm the message
7
Adjust the transfer conveyor width
10
13-5-2
9
Calibration
●When pressing [Key rate], you can
change the response.
7
①Use [Key rate] to set the moving amount.
②Use to move the
conveyor.
+
●Adjust the value of “Offset” so that the
difference of the offset value and the
measured value in step
becomes 320.6mm.
(The value is displayed in “Offset”.)
4
●Adjust the value so that the measured
value in step becomes between
320.5 and 320.7 mm.
4
NPM-TT2 EJM1EE-MB-13M-02
2
1
Placement position/
Conveyor 1
13-6-1
This operation procedure is also shared by the 8- and 3-nozzle heads.
Confirm the end processing of
the conveyor
+
(Calibration is carried out)
■To cancel
(The screen stays as it is in
on P.13-5-2)
9
1 2
■When width adjustment is performed in the
pre-process
■When width adjustment is not performed
in the pre-process
Maintenance
13-6
NPM-TT2 EJM1EE-MB-13M-02
13-6-2
Calibration
3
3
+
(The head moves to the work position)
Prepare to install nozzles
Open the safety cover
Install nozzles
●Nozzle used
Head
type
Nozzle
position
Nozzle
type
8 No. 3 230C
3 No. 2 1002
Close the safety cover
Servo switch OFF
4
5
6
7
8