N7201A653E - 第399页
NPM- TT2 EJ M1EE-MB-13M-0 2 13-14 -4 Calibration 17 19 20 22 21 23 23 18 ■ To cancel (The screen remains as it is in ) 11 Confirm the message + Open the safety cover Remove nozzles Close the safety cover Prepare to remov…
NPM-TT2 EJM1EE-MB-13M-02
13-14-3
Maintenance
13-14
Confirm that it has been
successfully completed
12
11
14
15
12
14
13
13
15
16
16
11
■To cancel
(The screen remains as it is
in )
11
Confirm the message
+
(The head moves to the working
position.)
Transfer 2
To check parameters
(Transitions to the screen of )
13
Check transfer position
offset
(Transitions to the screen of )
11
NPM-TT2 EJM1EE-MB-13M-02
13-14-4
Calibration
17
19
20
22
21
23
23
18
■To cancel
(The screen remains as it is
in )
11
Confirm the message
+
Open the safety cover
Remove nozzles
Close the safety cover
Prepare to remove nozzles
Servo switch ON
Servo switch OFF
NPM-TT2 EJM1EE-MB-13M-02
13-15-1-1
Overview 1
Accuracy
verifica-
tion
Maintenance
13-15-1
Accuracy verification
Explains considerations for accuracy verification.
■MCDATA type
Offset Refection MCDATA
The one with “Ost” included in its
data name
The front and rear heads execute placement independently from each
other, and the placement locations are measured. This is used to
reflect the each-position-angle offsets, obtained from measurement
results, separately as the front or rear head use.
Accuracy Verification MCDATA
The one with “Ins” included in its
data name
The front and rear heads execute alternate placement that is an
operation close to normal placement, and this is used in measuring the
placement locations.
MCDATA filename
T2 - M08 – M08 - F - F _ 05JIG - Ost ＊＊＊
①
②
③④ ⑤⑥
①
Machine name T2 (NPM-TT2)
②
Head
configuration
M08: 8-nozzle / M03: 3-nozzle
③
Supply unit
configuration
F: feeder / FT: Feeder + Tray feeder
④
Component 05JIG: 1005 jig component / 02R: 0402R / BGA: BGA jig component
⑤
Mode Ost: for offset reflection use / Ins: for accuracy verification use
⑥
Available nozzle
■Reflection of verification data
●When accuracy is verified using ‘Offset Refection
MCDATA’ (-Ost)
●When accuracy is verified using ‘Accuracy Verification
MCDATA’ (-Ins)
Make sure not to reflect the each-position-angle offsets, obtained after measurement, in “Accuracy verification
MCDATA” because the MCDATA is used for verification purpose.
When using MCDATA for component placement, the following message appears before the start of production.
Select [Yes] / [No] according to the type of the data you use.
MCDATA (production program) is exclusively used for accuracy verifications.
There are the following two types of MCDATA used for placement accuracy verifications.
+
+