N7201A653E - 第450页
NPM- TT2 EJM1EE-MB-14 M-02 14-9 -5 Maintenance 14-9 Ho w to s witch the 17-slot f eeder car t and the single tr ay f eeder 3 Attach the grommet Loosen the knob, move it from “TRA Y” t o “CHANGE” and fix Tray feeder joint…
NPM-TT2 EJM1EE-MB-14M-02
14-9-4
5
Remove the joint screw A and install it to the
temporary installation location
9
Attach the cover to the connector unit
10
●Screw: M4
2 locations
Detach the
feeder table
cover
Temporary installation location
Connector unit
To
11
4
Remove the cables and pipes and fix them using a cable tie
Cable tie
Clamping
band
Joint screw A
Cable, pipe
●Do not remove the clamping band
Cover
Installation
Fix the cover
●Screw:M4
Loosen
three screws
Loosen the screws and slide
the cover upward
●Screw:M4
Loosen
two screws
NPM-TT2 EJM1EE-MB-14M-02
14-9-5
Maintenance
14-9
How to switch the 17-slot
feeder cart and the single
tray feeder 3
Attach the grommet
Loosen the knob, move it from
“TRAY” to “CHANGE” and fix
Tray feeder joint section
2 locations
Attach the drive guide
●Screw:M5 3 locations
Attach the cart guide
①Switching the single tray feeder to the 17-slot feeder cart 2
●Screw:M5 3 locations
1211
Sensor switch
Knob
16
17
Align the position of hinges and seals and tighten the screws
Installed state
Align the position of seals to position the cart guide
Tighten the screws to fix
NPM-TT2 EJM1EE-MB-14M-02
14-9-6
To
19
18
B
Push the end of the drive unit
against the pin A, turn it
clockwise so that its groove
hits the pin B. Then tighten
the screws.
A
●Screw: M10 2 locations
15
Loosen the
screws of the
sensor bracket
14
Loosen the knob,
move it from
“CHANGE” to
“CART” and fix
Knob
Installation
13
Loosen the screws all the way
Install the cart drive unit
Loosen the screws, pull the knob toward you,
move the sensor bracket downward and
temporarily fix the screws
Sensor bracket
Sensor switch
●Screw:
M4 2 locations
●Screw: M4 2 locations
Sensor bracket
knob