N7201A653E - 第499页
NPM- TT2 EJM1 EE-MB-17M-00 17-5 -4 Detach the grommet ( → P .17-2-4) Attach the feeder table cover ( → P .17-2-3) Attach the tray feeder Attach the tra y feeder Reattach the cover at the bottom side so that the connector…
NPM-TT2 EJM1EE-MB-17M-00
Switch from the 17-slot
feeder cart to the single
tray feeder 3
Maintenance
17-5
Switch the sensor
Loosen the knob and
fix it at the [CHANGE]
position
Tighten the screws all the way
Pull the knob and move
up the bracket approx. 10
mm
Loosen the knob and
temporarily fix it at the
[CART] position
①Tighten the screws
①
②
②Finally tighten the knob
①
17-5-3
Remove the guides
(two types)
Loosen the screws of (b) Drive guide and (c) Cart guide and
remove them
②Cart guide
①Drive guide
①
②
Store the (b) Drive guide and (c) Cart guide in the switch cart
(→P.17-3-1)
(4 mm Allen wrench) ●3 location
8
9
(4 mm Allen wrench) ●3 location
(3 mm Allen wrench) ●2 location
(3 mm Allen wrench)
●2 location
NPM-TT2 EJM1EE-MB-17M-00
17-5-4
Detach the grommet
(→P.17-2-4)
Attach the feeder table
cover (→ P.17-2-3)
Attach the tray feeder
Attach the tray feeder
Reattach the cover at the bottom side so that the
connectors are exposed
(3 mm Allen wrench)
●3 locations
10 11
12
Adjust the height of the tray
feeder (If not yet to be adjusted)
1. Loosen the lock nuts.
2. Adjust the height using the adjustment
nuts.
3. Tighten the lock nuts.
●Adjust the height/level of the feeder as
shown in the figure below
The bubble should stay within 1 division
(0.1 mm/m)
Lock nut
Adjustment nut
Casters: 4 pcs
19 2 mm
Tray feeder
Multi-
Recognition
camera
Level gauge
13
Switch from the 17-slot
feeder cart to the single
tray feeder 4
Maintenance
17-5
(3 mm Allen wrench)
●2 locations
(Spanner 30 mm)
●Use two spanners
NPM-TT2 EJM1EE-MB-17M-00
Close the safety cover
Turn ON the power (→P.17-2-1) and
switching is complete
Attach the connection
screws to the right side
Remove the cables and plug them into the fitted connectors
Install the screw and the cables
Turn ON the safety switch of the tray feeder
Insert the metal part
①Rotate the connection
screw
②Rotate the metal part 45
degrees
Place the connection
screw on the side wall
①
②
Maintenance
17-5
14
15
17-5-5
16 17
Switch from the 17-slot
feeder cart to the single
tray feeder 5