N7201A653E - 第500页
NPM- TT2 EJM1 EE-MB-17M-00 Close the safety cover T urn ON the power ( → P .17-2-1) and switching is complete Attach the co nnection screws to the right side Remove the cables and plug them into the fitted conne ctors In…
NPM-TT2 EJM1EE-MB-17M-00
17-5-4
Detach the grommet
(→P.17-2-4)
Attach the feeder table
cover (→ P.17-2-3)
Attach the tray feeder
Attach the tray feeder
Reattach the cover at the bottom side so that the
connectors are exposed
(3 mm Allen wrench)
●3 locations
10 11
12
Adjust the height of the tray
feeder (If not yet to be adjusted)
1. Loosen the lock nuts.
2. Adjust the height using the adjustment
nuts.
3. Tighten the lock nuts.
●Adjust the height/level of the feeder as
shown in the figure below
The bubble should stay within 1 division
(0.1 mm/m)
Lock nut
Adjustment nut
Casters: 4 pcs
19 2 mm
Tray feeder
Multi-
Recognition
camera
Level gauge
13
Switch from the 17-slot
feeder cart to the single
tray feeder 4
Maintenance
17-5
(3 mm Allen wrench)
●2 locations
(Spanner 30 mm)
●Use two spanners
NPM-TT2 EJM1EE-MB-17M-00
Close the safety cover
Turn ON the power (→P.17-2-1) and
switching is complete
Attach the connection
screws to the right side
Remove the cables and plug them into the fitted connectors
Install the screw and the cables
Turn ON the safety switch of the tray feeder
Insert the metal part
①Rotate the connection
screw
②Rotate the metal part 45
degrees
Place the connection
screw on the side wall
①
②
Maintenance
17-5
14
15
17-5-5
16 17
Switch from the 17-slot
feeder cart to the single
tray feeder 5
NOTICE
The contents of this document are subject to change without prior notice.