MAN00000772_SI-G200BB_SVCPDFA - 第168页
Set-up HLGB-10201-01 RT A xis Origin Position Set up SHEET 1/4 R T Axis Origin Position Setup Perform this working on both heads on the front sid e and rear side. [Necessary jigs] • RT origin jig [Procedure] 1 Click in a…
Preparation for Calibration
HLGB-10106-01
Origin Return of the Unit (M/C ORG)
SHEET
2/2
5 Press [ORG] button in front of the unit.
When origin return is started, the green lamp on the
signal tower blinks.
< Operating sequence of origin return >
1. Origin return of H/F axis
For head on the front side, left front is origin
position, and for head on the rear side, right
depth is origin position.
2. Origin return of X/Y axis, RT/RN axis
Turn OFF the interlock key when removing the alternation cart after origin return or when opening the
door to perform working.
Since the function of the area sensor is enabled when the interlock key is ON, the unit is in the emergency
stop state if your hand etc is put into the unit.
Similarly, when the alternation cart is removed from the unit with the interlock being ON, the unit is in
the emergency stop.
Set-up
HLGB-10201-01
RT Axis Origin Position Setup
SHEET
1/4
RT Axis Origin Position Setup
Perform this working on both heads on the front side and rear side.
[Necessary jigs]
• RT origin jig
[Procedure]
1 Click in an order of MANUAL menu
PWB TRANSPORT tab Set button.
The backup plate rises.
2 Press the [ORG] button on the operation
panel to perform origin position return.
3 Display RT Axis Home screen.
1. Click in an order of M/C SETUP
menu M/C MAINTENANCE tab
Calibration button.
CALIBRATION screen is displayed.
RT origin jig
Set-up
HLGB-10201-01
RT Axis Origin Position Setup
SHEET
2/4
2. Click the Machine Setup button on the
CALIBRATION screen.
Machine Setup screen is displayed.
3. Click the RT Axis Home button on the
Machine Setup screen.
RT Axis Home screen is displayed.
4 Use the XY move screen to move the head
to a position where working is easily
performed.
1. Click the XY button on the RT Axis
Home screen.
XY Axis screen is displayed.
2. Click the Jog Move button in the move
mode.
3. Press the cursor key to move the head
to a position where working is easily
performed.
4. Press the Return button after the
head moves to close the XY axis
screen.