MAN00000772_SI-G200BB_SVCPDFA - 第191页
Set-up HLGB-10206-01 F Ax is Setup SHEET 4/5 7 Click the servo ON button on the F Axis Home screen. Servos for all axes are tuned on. 8 Click the Save button. Height of the F ax is is saved, and the F Axis Home screen cl…
Set-up
HLGB-10206-01
F Axis Setup
SHEET
3/5
2. Click the Jog Move button.
3. Press the cursor key to move the feed
part onto the feed adjusting jig.
4. Place the part feed height jig
(110.4mm) on the feed adjusting jig.
5. Adjust position so that center of the
feed roller is on the center of the part
feed height jig.
5 Click the servo OFF button on the F Axis
Home screen.
Servos for all axes are turned off.
6 Rotate the pulley of the F axis belt to lower
the feed roller to the setup position.
1. Pinch a thickness gauge of 0.1mm on
the part feed height jig.
2. Rotate the pulley of the F axis belt to
lower the feed roller to a position
where it contacts the thickness gauge.
Feed adjusting jig
Feed roller
Part feed
height jig
Part feed height jig (110.4 mm)
Feed roller
F axis belt
Feed roller
Thickness gauge
(t = 0.1 mm)
Set-up
HLGB-10206-01
F Axis Setup
SHEET
4/5
7 Click the servo ON button on the F Axis
Home screen.
Servos for all axes are tuned on.
8 Click the Save button.
Height of the F axis is saved, and the F Axis Home
screen closes.
9 Change the thickness gauge to 0.2mm, and
check that it is not inserted into a gap
between the feed roller and the part feed
height jig.
10 Close the Machine Setup screen and
Calibration Menu screen.
11 Press the [ORG] button on the operation
panel to perform origin position return.
12 Check the set F axis height.
1. Click in an order of MANUAL menu
CASS. tab.
2. Input “120” into the cassette position
space, and click the Move.
3. Press the [START] button on the
operation panel.
The head moves to No.120 cassette position.
4. Replace the parts feed height jig
(110.4mm) on the feed adjustment jig
with a parts feed height jig of 86.5mm.
Feed adjusting jig
Part feed height jig
(86.5 mm)
Set-up
HLGB-10206-01
F Axis Setup
SHEET
5/5
5. Click in an order of AXIS MOTION
tabF button.
FF Axis screen is displayed.
6. Place a check in “Normal Cassette”
and “Down” and press the [START]
button on the operation panel.
The feed roller lowers.
7. Check that clearance between the
parts feed height jig (86.5mm) and the
feed roller is in a range of 0<0.2mm
with a thickness gauge.
8. After checking, place a check in the
“Up” on the FF axis careen, and press
the [START] button.
13 Also check the height of the F axis on the rear side by the same procedure as in the procedure 12.
Feed roller
Feed roller
Thickness gauge