MAN00000772_SI-G200BB_SVCPDFA - 第42页

Install Tray Unit (Including machine modification) SHEET 3/73 WKGB-10104-03 Installing Tray Unit (Including machine modification) [Changing conveyor wid th specification] 1 Move the CV axis origin sensor and CCW sensor t…

100%1 / 712
Install Tray Unit (Including machine modification)
SHEET
2/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
［Checking conveyor width specification］
SI-G200 tray specifications are different from each other in tray pallet supportable dimension depending on
conveyor width.
Check dimension of tray pallet to be used for the unit in advance to change conveyor width specification if
necessary.
Reference:
JEDEC standard tray size
X=322.6[mm], Y=135.9[mm] can be supported by CV width specification
410[mm].
1 Pickup enable area when CV width specification is 410[mm]
2 Pickup enable area when CV width specification is 360[mm]
5.0[mm]
336.0[mm]
341.0[mm]
225[mm]
Nozzle operating range
Placing enable tray size
5.0[mm]
336.0[mm]
341.0[mm]
175.5[mm]
Nozzle operating range
Placing enable tray size
225[mm]
Install Tray Unit (Including machine modification)
SHEET
3/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Changing conveyor width specification]
1 Move the CV axis origin sensor and
CCW sensor together with the brackets.
2 Change the M/C setup.
1. Change "CV_WIDTH=410" in
"c:¥asm¥mcdata1¥asmconfig.ini" to
"CV_WIDTH=360."
2. Input a value obtained by subtracting "50" from
the value of "SOFT_LIMIT_PLUS" in
"c:¥asm¥mcdata1¥pm_param.ini."
3 Restart the unit.
4 Input origin offset value so that the
conveyor width becomes actual PWB
dimension +0.2[mm].
NOTE:
When you want to broaden the
conveyor width, subtract from the input
value. When you want to narrow the
conveyor width, add to the input value.
5 If you changed the conveyor width
specification to 360[mm], change
the position of the nozzle sensor
also.
Install Tray Unit (Including machine modification)
SHEET
4/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Change position of Nozzle sensor]
Execute this work if you have changed the specification of the width to 360[mm].
If the conveyor specification is standard, we don't need to do this work.
1 Remove rear side center cover and shooter.
2 Loosen 2-CP3x6, and change the position of
Nozzle sensor.
3 Set up again nozzle sensor.
For procedure of nozzle sensor adjustment, refer to
the “Nozzle sensor Adjustment [HLGB-10415-01].”