MAN00000772_SI-G200BB_SVCPDFA - 第636页
10 Part s Replacing Manual
5. Optional
TFGB-10101-01
SI-G200 (B Head) Overview
SHEET
20/20
<Points to Note>
- Adhesion detection for the last part to be mounted on a PWB is performed after the last part has been
mounted (after the H axis has ascended).
5-3-2 Missing Part Detection(Optional)
[Missing Part Detection Operation]
On the part mounting position, the pickup check camera checks whether a part to be mounted is missing.
In the same way as the conditions for part thickness check, missing part detection can be performed only
for parts that can be recognized by the pickup check camera (parts in Category A).
[When a Part Is Actually Missing]
- When a part has dropped on a PWB, remove it.
- For a missing part, specify the start and stop
steps in [Step Specification] on the “Motion
Setup (Unit)” screen displayed after “Automatic
Production” has been selected, and mount
another part again.
<Points to Note>
- After the H axis has descended in the mounting operation, the result of missing part detection can be
obtained. Therefore, the nozzle tip may contact the solder on the surface of a PWB, depending on the
push-in amount of the nozzle when a part is mounted.
10 Parts Replacing Manual
