MAN00000772_SI-G200BB_SVCPDFA - 第656页

Pickup Check Camera Part RPGB-10202-01 Pickup Check Light Up/Do wn Cylinder Replacement SHEET 1/7 Pickup Check Light Up/Down Cylinder Replacement [Necessary jigs] • Spanner (width across flats: 3 [mm]) 3.0 mm [Removing t…

100%1 / 712
Pickup Check Camera Part
RPGB-10201-01
Pickup Check Camera Up/Down
Cylinder Replacement
SHEET
7/7
15 Move the cylinder up and downward to
adjust the installing position of the cylinder
up/down sensor.
1. Click the Check button on the ORG
OFFSET screen of the M/C SETUP.
2. Adjust the sensor position so that LED
on the sensor lights up at positions of
cylinder rising end and lowering end.
16 Execute pickup camera set up and pickup check camera calibration.
・ For the pickup check camera setup procedure, refer to “Pickup Check Camera Setup [HLGB-10208-01]”.
・ For the pickup check camera calibration procedure, refer to “Pickup Check Camera Calibration [HLGB-10308-01]”.
Cylinder up senso
r
Cylinder down
senso
r
Pickup Check Camera Part
RPGB-10202-01
Pickup Check Light Up/Down
Cylinder Replacement
SHEET
1/7
Pickup Check Light Up/Down Cylinder Replacement
[Necessary jigs]
• Spanner (width across flats: 3 [mm])
3.0 mm
[Removing the Cylinder]
1 Move the head to a better position to work
with, and then turn off the power of the
mounter.
2 Disconnect air supply of mounter.
3 Disconnect the connector of SSB-3 and
SSB-5 from the SSB board on the side of
the head.
Remove the cable tie (Insulock) from the cables.
4 Disconnect the connector of LEDF2
(LEDR2) from the LED light unit.
5 To prevent the light unit from falling off,
fasten the light unit to the motor bracket
using the cable tie (Insulock).
SSB board
SSB-3
SSB-5
LEDF2 (LEDR2)
Light unit
Pickup Check Camera Part
RPGB-10202-01
Pickup Check Light Up/Down
Cylinder Replacement
SHEET
2/7
6 Remove CP2x6 from the rod end.
Use caution not to drop the collar.
7 Remove the cable tie (Insulock) fastening
the light unit, and then remove the light unit
together with the slide block.
8 Loosen 2-CP2.5x22 screw to remove the
cylinder.
9 Disconnect two air tubes from the air
cylinder.
To prevent connected mistake when
re-assemble, please mark to the air tubes before
disconnecting.
CP2x6
Cylinder
Light unit
CP2.5x22
Cylinder
A
ir tube