MAN00000772_SI-G200BB_SVCPDFA - 第657页
Pickup Check Camera Part RPGB-10202-01 Pickup Check Light Up/Do wn Cylinder Replacement SHEET 2/7 6 Remove CP2x6 from the rod end. Use caution not to drop the collar . 7 Remove the cable tie (Insulock) fasteni ng the lig…
Pickup Check Camera Part
RPGB-10202-01
Pickup Check Light Up/Down
Cylinder Replacement
SHEET
1/7
Pickup Check Light Up/Down Cylinder Replacement
[Necessary jigs]
• Spanner (width across flats: 3 [mm])
3.0 mm
[Removing the Cylinder]
1 Move the head to a better position to work
with, and then turn off the power of the
mounter.
2 Disconnect air supply of mounter.
3 Disconnect the connector of SSB-3 and
SSB-5 from the SSB board on the side of
the head.
Remove the cable tie (Insulock) from the cables.
4 Disconnect the connector of LEDF2
(LEDR2) from the LED light unit.
5 To prevent the light unit from falling off,
fasten the light unit to the motor bracket
using the cable tie (Insulock).
SSB board
SSB-3
SSB-5
LEDF2 (LEDR2)
Light unit
Pickup Check Camera Part
RPGB-10202-01
Pickup Check Light Up/Down
Cylinder Replacement
SHEET
2/7
6 Remove CP2x6 from the rod end.
Use caution not to drop the collar.
7 Remove the cable tie (Insulock) fastening
the light unit, and then remove the light unit
together with the slide block.
8 Loosen 2-CP2.5x22 screw to remove the
cylinder.
9 Disconnect two air tubes from the air
cylinder.
To prevent connected mistake when
re-assemble, please mark to the air tubes before
disconnecting.
CP2x6
Cylinder
Light unit
CP2.5x22
Cylinder
A
ir tube
Pickup Check Camera Part
RPGB-10202-01
Pickup Check Light Up/Down
Cylinder Replacement
SHEET
3/7
10 Disconnect the cylinder sensors from the
cylinder.
Cylinder sensor