MAN00000772_SI-G200BB_SVCPDFA - 第68页
Install Tray Unit (Including machine modification) SHEET 29/73 WKGB-10104-03 Installing Tray Unit (Including machine modification) 10 Connect the fiber line to the sensor amplifier . NOTE: Connect the fiber line so that …
Install Tray Unit (Including machine modification)
SHEET
28/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
8 Install the sensor bracket to the cassette
table.
NOTE:
Temporarily fix the sensor bracket.
NOTE:
Bind the fiber line with INSULOCK.
9 Connect the sensor amplifier and the
connector 375 on the main body.
2-CP4x8
Fiber line binding
2-CP4x8
Cassette cable
Fiber line
Cassette table
Tie mount
Install Tray Unit (Including machine modification)
SHEET
29/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
10 Connect the fiber line to the sensor
amplifier.
NOTE:
Connect the fiber line so that the left side is
floodlighting and the right side is light receiving
toward the rear operation panel.
NOTE:
Bind the fiber line against the mount at the lower
section of the cassette table, and cut the extra fiber
line.
Cassette table
Cassette table
Tie mount
Upper: Floodlight
Lower: Light receiving
Install Tray Unit (Including machine modification)
SHEET
30/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Assembly and installation of tray specification shooter]
1 Sticking address seal.
1. Cut address seal by 301[mm] long from the left
end.
NOTE:
Supply No. of tray specification is
No.101 to 117.
2. Set the left end of the address seal to a position at
16[mm] from the left end of shooter address
indicating section, and stick it.
2 Assemble the upper shooter of the tray
specification and the existing lower
shooter with the 4-+T4x8.
NOTE:
For the lower shooter, the existing shooter is commonly
used.
3 Install the shooter for tray specification with
the 4-+T4x8.
1 2 3 4 5 6
13 14 15 16 17 18 19 20
301[mm]
16.0[mm]
１
Shooter
Address seal
Lower shooter
(commonly used)
Upper shooter (only for tray specification)