MAN00000772_SI-G200BB_SVCPDFA - 第692页

Ch ange Procedu re fo r Head Un it Leve r Asse mbly 5 Remov e the screws (2-C2.5x 5) and H ax is sensor do g. 6 Remov e the screws (4-C3x 4) and L eve r assembly . 7 Remov e the screws (2-C2.5x 4) and r ack. PO INT Repla…

100%1 / 712
Change Procedure for Lever Assembly of Head Unit
5. Remove the pipe fitting.
Then remove the pickup check up/down unit.
POINT
Use 7mm wrench
4 Remove the 2-C4x16 and the rail holder.
CAUTION
Support the edge of rail when remove the rail holder.
LM guide should not come off for upper side.
After removed it, prevent to come off the tip by cable tie.
Rail Holder
C4x16
LM Guide
Change Procedure for Head Unit
Lever Assembly
SHEET
3/7
RPGB-11101-1
M7 wrench
Pipe Fitting
Change Procedure for Head Unit Lever Assembly
5
Remove the screws (2-C2.5x5) and H axis sensor dog.
6 Remove the screws (4-C3x4) and Lever assembly.
7 Remove the screws (2-C2.5x4) and rack.
POINT
Replace the cam-follower together when you change lever.
Remove with pliers when you replace only the cam-follower.
Does not come off in wrench because it is glue.
C2.5
x
5
H axis sensor dog
C3x4
Lever ass’y
Change Procedure for Head Unit
Lever Assembly
SHEET
4/7
RPGB-11101-1
C2.5x4
Rack
Lever
Cam-Follower
Change Procedure for Head Unit Lever Assembly
[Reassembly]
8 Install the Cam-follower to the new lever
1.Apply locktite 242 to the part of the screw.
Tighten from the tightening hole with the wrench.
9 Apply locktite 242 to the screws (2-C2.5x4).
Attach the rack to the new lever assembly
and tighten the screws.
POINT
Attach the rack while touch to the lever.
10 Apply the Locktite 242 to the screws (4-C3x4),
attach the lever assy to the LM guide.
POINT
Attach the lever assy while touch in the direction of arrow.
Refer to figure.
11
Apply the Locktite 242 to the screws (2-C2.5x5)
attach the H axis sensor dog to the lever assembly,
tighten the screws.
12 Attach the rail holder to the H axis motor bracket,
tighten the screws (2-C4x16).
Change Procedure for Head Unit
Lever Assembly
SHEET
5/7
RPGB-11101-1
C2.5×4
Rack
lever
Cam-follower
Tightening hole
C2.5
x
5
H axis sensor dog
C3x4
Lever Assy
C
レ