MAN00000772_SI-G200BB_SVCPDFA - 第73页

Install Tray Unit (Including machine modification) SHEET 34/73 WKGB-10104-03 Installing Tray Unit (Including machine modification) [Inst allation of mount bracket] 1 Inst all the mount bracket to the S axis frame accordi…

100%1 / 712
Install Tray Unit (Including machine modification)
SHEET
33/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Installation of S axis unit]
1 Remove the discard box.
NOTE:
The unit of tray specification essentially uses the
discard box.
2 Loosen the 8-+T4x8 on the upper
section of the S axis unit to remove the
cover.
3 Set to the position of the parallel pin on
the cassette table and place the S axis
unit on the cassette table.
NOTE:
Be careful not collide to the fixed camera.
4 Fix the S axis unit with the 4-CP6x20.
5 Install the cover using the 8-+T4x8.
410 ㎜
360 ㎜
Install Tray Unit (Including machine modification)
SHEET
34/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Installation of mount bracket]
1 Install the mount bracket to the S axis
frame according to the conveyor width
specification.
NOTE:
Apply LOCKTITE 242 into the M10 thread
section on the spacer for mount base.
NOTE:
Fix temporarily at the position in which the
mount bracket was drawn out
outside of the machine.
360mm
410mm
Unit body side→
← Tray unit body side
Spacer
Spacer for mount base
Install Tray Unit (Including machine modification)
SHEET
35/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Connection with main body]
1 Connect the tray coupling I/F plate and S
axis, V axis units.
1. Connect the AIR tube on the tray I/F plate to the
manifold on the lower section of the S axis with air
tube ofφ6.
2. Connect each connector on the tray I/F plate to
each connector on the V axis unit.
TY-MLOUT <======> CU-1
TY-CTLOUT <======> TY-CTL
TY-ACOUT <======> TY-ACIN
3. Connect the S axis unit and the V axis unit.
S-SMT1 <======> S-SMT2
VD-IO <======> S-IO
NOTE:
At this time, do not dock the tray unit and the
main body yet.
2 Bind the cable with spiral tube after
connection.
TY-MLOUT
T
Y
-CTLOUT
T
Y
-ACOUT
AIR
CU1
TY-CTL
TY-ACIN
VD-SMT
VD-IO
S-SMT2
S-IO