MAN00000772_SI-G200BB_SVCPDFA - 第93页
Install Tray Unit (Including machine modification) SHEET 54/73 WKGB-10104-03 Installing Tray Unit (Including machine modification) [Setup of tray supply height] 1 Remove front middle cover and rear upper cover . 2 Adjust…
Install Tray Unit (Including machine modification)
SHEET
53/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
15 Adjust the height of the caster until
lightly getting to the floor.
NOTE:
If you changed shutter sensor position or shutter roller
position until this step, please adjustment it again.
NOTE:
For re-adjustment shutter roller, refer to “Adjustment
shutter roller [HLGB-10430-01]”.
For re-adjustment shutter closing detect sensor, refer to
“adjustment shutter closing detect sensor
[HLGB-10431-02]”.
Install Tray Unit (Including machine modification)
SHEET
54/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
[Setup of tray supply height]
1 Remove front middle cover and rear upper
cover.
2 Adjust a right and left tilt of the tray unit
according to the tilt of S axis.
1. Set the palette to Z501.
2. Display operation window of VU axis from Feeder &
Tray group of ORG OFFSET screen on M/C SET
UP mode.
3. Move the pallet that in Z501 to supply height.
4. Display CASS screen of manual mode. And Open
shutter.
Install Tray Unit (Including machine modification)
SHEET
55/73
WKGB-10104-03
Installing Tray Unit
(Including machine modification)
5. Confirm the smooth movement of the palette from
the tray rack.
NOTE:
Adjust the height of the tray rack again if palette can
not move smoothly.
NOTE:
Adjust the inclination of the tray unit according to S
axis unit, when there are differences of the inclination
S axis unit and tray unit.
S-axis Unit
Tray rack
S-axis Unit
Tray rack