00192801-01 - 第87页
User Manual V 1.15 - Productivity Lift 12 Reinstallation Software version V 40. 1 1 Edition 01/2001 12.1 Reinstallation 79 5HLQVW DOODWLRQ This cha pter e xplains how to reins tall the d evice. A qu alified p erson or…
11 Fault information User Manual V 1.15 - Productivity Lift
Software version V 40.11 Edition 01/2001
78
)DXOW6KXWWOH
The shuttle movement is faulty.
Check the pneumatic air and position of the sensors.
:DLWIRULQWHUIDFH
The arrived signal is not received following the transfer of a PCB.
Check printed circuit board transfer; PCB may have been jammed during
transfer.
/)
75 75
User Manual V 1.15 - Productivity Lift 12 Reinstallation
Software version V 40.11 Edition 01/2001 12.1 Reinstallation
79
5HLQVWDOODWLRQ
This chapter explains how to reinstall the device. A qualified person or employee (service engi-
neer) may only do this.
127(
For reinstallation, dismantling or disposal the Productivity Lift has to be prepared. For installation
please refer to Installation instruction (Article No.: 00191 967-01).
5HLQVWDOODWLRQ
If the Productivity Lift needs to be removed or moved within a production line, please follow
the instructions below.
1. Position the Top Conveyor in its lowest position using the manual mode and install transport
locks (see chapter 2.5).
2. Position Shuttle Conveyor in its lower position and tighten Mount shaft clamp Figure 2 - 3, Page
14) to secure Shuttle Conveyor.
3. Press the button marked "Stop" on the system control panel.
4. Set the main switch to the "0" position.
5. Disconnect the power supply via the main cable and pack it into the control cabinet.
6. Disconnect any pneumatic energy supply by removing the feed hose. Pack it sensibly into the
system.
7. Remove any transport goods and magazines intended for this purpose from the device.
8. Remove the keys for the key switch located in the control cabinet to bridge the safety switches
of covers and doors.
9. Close and lock all doors and covers.
12 Reinstallation User Manual V 1.15 - Productivity Lift
12.2 Dismantling Software version V 40.11 Edition 01/2001
80
'LVPDQWOLQJ
Pack and transport the unit after disconnecting, power cords, interface cables and compressed
air lines. Please follow the relevant Safety and Transport regulations during this process.
'LVSRVDO
Only "operators" have responsibility for disposal. They must ensure that the system and its oper-
ating supplies are disposed of correctly.
The construction of the system only involved materials that can be easily recycled or are not harm-
ful when destroyed. Dangerous substances are not necessary for either the construction or oper-
ation of the device.
The relevant national legal provisions must be complied with when disposing of the different de-
vice parts.
'LVSRVLQJWKHGHYLFH
Dispose of the device by taking it apart, sorting the parts separately according to material, and
disposing of them accordingly.
The device consists of the following materials:
Frame : steel
Panelling : steel and plastic
Mechanical components : aluminium
Controller : plastics, non-ferrous metals and electronic components