WaferTransportSolutionManual - 第109页

INSTALLATION EQUIPMENT INSTALLATION Chapter Issue 1 Aug 11 Wafer Transport Solutio n 3.33 W arning Labels Check that the correct warning labels are attached to the approp riate areas of all machines. Situated behind the …

100%1 / 116
INSTALLATION
EQUIPMENT INSTALLATION
3.32 Wafer Transport Solution Chapter Issue 1 Aug 11
a gap between the point of each screw and the lift cylinder arms.
25. Repeat Steps 20 and 21 to check the top plates remain within the stated
tolerance.
26. Remove the paper sheet and the gauge and the stand.
27. Close the printhead front cover.
28. Reset the E Stop.
29. Press the System button.
30. Select Toggle Board Clamps.
31. Open the printhead front cover.
32. Remove the pallet and shim.
33. Close the printhead front cover.
34. Press the System button.
Lift Cylinder Arm
Maintain Gap0.05mm
Safety Screws
Rear Top Plate
INSTALLATION
EQUIPMENT INSTALLATION
Chapter Issue 1 Aug 11 Wafer Transport Solution 3.33
Warning Labels Check that the correct warning labels are attached to the appropriate areas of
all machines.
Situated behind the safety covers
Situated on the
safety covers
INSTALLATION
EQUIPMENT INSTALLATION
3.34 Wafer Transport Solution Chapter Issue 1 Aug 11
Running a Product
WARNING
HEAVY OBJECT. EXTREME CAUTION SHOULD BE EXERCISED WHEN
MANUALLY HANDLING HEAVY ITEMS INTO OR OUT OF THE MACHINE.
Semi Automatic
Load
In this mode of operation, the operator must load pallets into and out of the
NUTEK transfer station.
The printer is set up and ready to run. Assume that the print mode is left to left.
1. Turn the transfer station’s mains isolator to ON.
2. Open the transfer station’s front cover.
3. Check that the pallet is laid flat onto the transport rails and a shim is placed
on the pallet.
4. The pallet is positioned ensuring it covers both alignment sensors.
5. The keyswitch mode is MODE1 for Left to Left conveyor operation
Rail End Sensor
Left Alignment Sensor Right Alignment Sensor
Rail Width Adjuster Rail Width AdjusterKey Switch
Mains Isolator
E Stop
Power
Lamp Vacuum Vacuum
Start Plate Reset ON OFF